What happens when you plug in the wrong power adapter?
I later found the correct cable and when i put it in the inner light was still blinking and the mybook was not coming on at all, it was completely silent and the fan was not even spinning. The green power light on the cable is also blinking when it is plugged into the mybook but it is steady when it is taken out.
What should I do if my light switch doesn’t work?
If the lamp fails to light at all, check the wiring between the fuse and switch. If the lamp only lights on one terminal, the switch is either broken or needs adjusting. To replace a reversing light switch, disconnect the wiring and either unscrew the switch or, if a locknut is used, release this.
Why are my trailer lights not working properly?
If the output is going in and back on the right wires, the reason may be wrong trailer wiring, including improper ground wire connection, dirt or rust buildup, pinched or cut harnesses. Troubleshooting trailer lights can appear to be intricate, but a good visual inspection can take a great deal of problems off.
Why is my left channel speaker not working?
Most likely, the left channel speaker, which was working before, will not work. This proves that the right channel speaker terminals on the amplifier or receiver are not working. At this point, you have pretty much established that the problem is the right channel speaker output from the receiver or amplifier, and not the speaker or wires.
Why is the right turn signal light not working?
Back probe the wire that supplies power to the right turn signal lights; the test light should not light. If the test light illuminates, replace the switch. Repeat the test, but this time operate the switch so the right turn signals light.
Why are there so many wires in my LED light?
Overloading wire connectors is the most common mistake when installing LED lighting products. When there are too many wires in a connector that is designed for a single wire this can cause serious fire hazard issues if a short occurs or the wires begin to arc.
What should I do if my light fixture is not working?
Check the connections at the switch and make sure that they are tight. Be sure that the power is off to the circuit that you are working on. With the power shut off, check the wire connections at the light fixture and at the breaker panel to make sure they are all connected tightly.
Is it OK to leave bare wire splices on LEDs?
Leaving bare wire splices exposed puts your installation at risk for an electrical short and potential fire hazard. Always use proper wire connectors and never leave bare wire splices exposed. Overloading wire connectors is the most common mistake when installing LED lighting products.