What happens to the blower motor on a Toyota Camry?
The blower motor resistor is the part responsible for controlling the blower. When it stops working, the HVAC controls also stop working. This article will show you how to fix it. This article applies to the Toyota Camry (1997-2001).
What happens if you blow the head gasket on a Toyota Camry?
If your Toyota Camry has blown its head gasket, you may find it running poorly or not at all. Below you’ll find the symptoms, causes, and price of a Toyota Camry head gasket. A head gasket’s job is to create a seal between the engine block and the head (s). Outside of this job, it needs to fail before the head cracks or warps.
How to troubleshoot the air conditioning in a Toyota Camry?
How to Troubleshoot the Air Conditioning in a Toyota Camry Start the engine and let it to run for a few minutes to allow the air to cool. Double check the controls to make sure the correct buttons are selected. This may seem simplistic, but human error could be to blame. Adjust the climate controls.
Where is the resistor on a Toyota Camry?
The resistor should be off to the side connected to the same group of cables that connects to the blower motor. To remove it, simply disconnect the cable harness then remove the two Phillips head screws. Then you need to wiggle it out from the compartment. Figure 1. Blower motor resistor is to the left of the motor.
When did the blower on my Toyota stop working?
Pirates here at the dealership wanted $169.0 😆 Yeah NOT. Blower stopped working last Thursday, It came back on Friday after I wiggled the blower motor resistor, went back out Saturday. It doesn’t work on any speed.
What to do if your AC blower is not working?
Disconnect cables to motor and resistor. Remove hose from motor, it should just pull off with little effort. Unscrew motor and resistor. Screw new motor and resistor in. Connect hose to motor. Connect cables to motor and resistor. Turn on car and test AC. Thanks for watching! Loading…
Why is the blower motor not working on my car?
My car has an automatic transmission. Hi There, The resistor is what controls the speed of the blower motor, not the relay. The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all.