What happens if you replace a seat control module?
If functionality has returned than it is safe to say the module you replaced has a problem. What has been found in the past is that is that the circuit board becomes worn and the process will sever the connections on the board. Photos below will help in fixing the problem.
How can I program the seat control in a 2003 suburban?
I’m sorry to have to tell you this, but there is no method for the individual to program one of these modules on your own. Programming the module requires the diagnostic tool connected to the GM programming server via the Internet. This programming loads the firmware specific to that module as well as your serial number into that module.
How to replace the driver’s door module on a car?
Ignition off Remove the door panel Remove the nut and screw holding the door module Disconnect the connectors Pry up the rear edge of the door module. Pull the door module backwards and upwards. Remove the door module from its mounting on the door panel Press up the door module. To remove the upper panel, see Removing the upper panel. Page 1 of 4
Where do I place the passenger door module?
Check that the control module connectors are intact. This method of installation applies to both the driver door module (DDM) and the passenger door module (PDM). Position the door module in the hole on the door panel.
What to do if your seat control module is not working?
The first step in troubleshooting your seat not functioning is to check the fuses, if all are good see about swapping one seat control module with the other seat module and see if all functions are working. If functionality has returned than it is safe to say the module you replaced has a problem.
I’m sorry to have to tell you this, but there is no method for the individual to program one of these modules on your own. Programming the module requires the diagnostic tool connected to the GM programming server via the Internet. This programming loads the firmware specific to that module as well as your serial number into that module.
How do you replace seat adjustment switch on Pelican?
Slide the plastic locking tab to the side to release the harness from the module. Re-insert the harness into the module, slide the locking tab to secure the harness and turn the ignition on. Check if the switch works now.
How do you repair a seat adjustment switch?
To repair the switch, you’ll need to need to remove the circuit board from inside the switch housing. Begin by prying the back cover off the switch. This is done by placing a small flat head screwdriver into the slots shown here (green arrows).