What happens if the pinion seal on a Chevy truck leaks?
If the pinion seal begins to leak, the fluid level can drop enough to damage those internal components and result in an expensive repair. Raise the rear of your Chevy off the ground with a jack and position a set of jack stands under the axle housing. Lower the jack and allow the truck to settle onto the jack stands.
What to do about a leaking rear main seal?
If you’re out of options, this is a fairly low cost method that has worked for some people with a leaking rear main seal. Just add one 8 oz. bottle for every 8 quarts of engine oil and it should at least slow down the leak and may even stop it.
How much does it cost to replace a rear main seal?
Replacing a Rear Main Seal Rear main seal leaks are often killers of engines due to their complicated replacement procedure. The actual seal that is broken is often a relatively low-cost part, often under $50 dollars but sometimes as low as $15.
Can a rear differential pinion seal be replaced?
I purchased a seal that was for my truck but once i got my seal out it turned out my truck did not have the standard 1/2 axle in it. It seems to be that it has been swapped out for a 1 ton limited slip rear end. it’s been a week after doing the project and all seems to be good there isn’t any leaks at all what so ever. Loading…
If the pinion seal begins to leak, the fluid level can drop enough to damage those internal components and result in an expensive repair. Raise the rear of your Chevy off the ground with a jack and position a set of jack stands under the axle housing. Lower the jack and allow the truck to settle onto the jack stands.
I purchased a seal that was for my truck but once i got my seal out it turned out my truck did not have the standard 1/2 axle in it. It seems to be that it has been swapped out for a 1 ton limited slip rear end. it’s been a week after doing the project and all seems to be good there isn’t any leaks at all what so ever. Loading…
Can a rear main seal leak be repaired?
Either of these issues will be substantially less difficult to deal with since they’re easier to get to. The problem with the rear main seal leak is that it requires much of your engine to be disassembled – so the labor is typically too much to do at home and the labor costs skyrocket when you take it to the shop.
How do you replace a seal on a Chevy truck?
Drive the seal into the bore with a seal driver and hammer than slide the yoke back onto the pinion shaft, making sure the marks you made on the yoke and shaft align. Install the pinion nut and tighten it, seating the yoke on the shaft.