What fuse blows when you hook a battery up backwards?
It can be a 40, 60 or 80-ampere fuse and this is rare finds. When the jumper cables are connected reversely, it may blow a fuse. After replacing the fuse, you can start up the vehicle. It should start up the car, if it doesn’t start, proceed to step 2.
What happens if you jump start a car backwards?
When the jumper cables are incorrectly connected, the polarity of the electrical system on the vehicle with the dead battery will be reversed for a few seconds. This can irreparably damage many of the sensitive electronic components that are common on today’s vehicles, such as on-board computers and electronic sensors.
Why does my car only start when I jump?
If jump starting gets your engine started and running, but the car will not start again once you turn it off, the battery is probably the problem. In this case, the alternator is doing its job of keeping the battery going once it has been jumped, but the battery can’t hold a charge when the alternator is shut off.
Do I connect the positive or negative first?
“Positive first, then negative. When disconnecting the cables from the old battery, disconnect the negative first, then the positive. Connect the new battery in the reverse order, positive then negative.”
What happens when you connect a jumper cable backwards?
Connecting the jumper cables backwards will often result in one or more blown fuses. The affected circuit will not function correctly until the blown fuse is replaced. Reversing the battery cables creates a surge of electrical current that can easily damage the battery.
Where does the red jumper cable go on a car?
The other end of the red cable connects to the positive terminal of the good battery. One end of the black (negative) jumper cable connects to the negative battery terminal of the good battery. The other end of the black jumper cable connects to a good ground on the vehicle that won’t start.
What happens if you connect a jumper cable to a dead battery?
Connecting the jumper cable to the negative terminal of the dead battery can create sparks and potentially cause an explosion. You should never attempt to jumpstart a frozen battery, as doing so can cause it to explode. Remove the dead battery, bring it inside, and allow it to thaw before attempting to jumpstart the vehicle.
Where are the clamps on a jumper cable?
Typically, jumper cables (also known as jump leads), come in a set of two wires with a copper clamp at each end. The clamps are assigned to either the negative pole or the positive pole on the battery. This is indicated by a “-” and “+”, respectively.