What does the p0122 code on the TPS sensor mean?
P0122 code definition Throttle Pedal Position Sensor/Switch (TPS) A Circuit Low Input What the P0122 code means The P0122 is the generic OBD-II code which indicates that the Engine Control Module (ECM) has seen the TPS sensor circuit A output voltage go below the sensor’s expected range.
What does P0158 mean on the oxygen sensor?
Therefore, the downstream oxygen sensor (sensor 2) should produce a steady voltage of approximately 0.45 volts. When trouble code P0158 is set, this indicates that there is a high voltage (steadily above .9 volts) for more than 10 seconds indicating a lack of oxygen in the exhaust stream and an abundance of fuel at sensor 2 on bank 2 of the engine.
What does the code p0122 on the ECM mean?
What Does Code P0122 Mean? Code P0122 is triggered when your vehicle’s Engine Control Module (ECM) detects that your Throttle Position Sensor (TPS) circuit A is reporting an output voltage that is below its expected voltage.
What are the symptoms of a P0158 DTC?
Symptoms of a P0158 DTC may include: MIL (Malfunction Indicator Lamp) on Engine loses power and misses intermittently May exhibit loss of fuel efficiency Potential causes of an P0158 code include: Wiring in contact with exhaust components Engine running rich (If other codes are present)
What does the p0221 code stand for?
Cost of diagnosing the P0221 code. P0221 is a diagnostic trouble code (DTC) for “Throttle/Pedal Position Sensor/Switch B Circuit Range/Performance Problem”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
When does the EPs warning light come on?
When the light is illuminated, it means that the EPS system is not functioning properly, and the vehicle should be serviced. Tip Like all warning lights, the EPS warning light briefly illuminates when the car is turned on. The light is only a problem if it stays lit when the engine is on.
What does the electric power steering system ( EPS ) Warnin?
Hi there: The problem with changing out the camshaft position sensor is that sometimes the issue is actually due to the sensor wiring harness; which might be the reason this OBD-II error code was triggered initially. The P-0340 trouble code… Hi and thanks for contacting YourMechanic.