What does the OBD code p0708 stand for?
OBD-II Code P0708 is defined as a Transmission Range Sensor Circuit High Input The purpose of the automatic transmission is to match the engine’s optimum power and torque characteristics to the driver’s desired rate of acceleration and speed by auto-selecting different gear ratios or ‘speeds’ to power the wheels.
What does the p0708 transmission range sensor do?
The PCM or TCM uses the transmission range sensor, also called the inhibitor switch, to determine the position of the shift lever. If it receives signals that indicate two different gear positions at the same time for more than 30 seconds P0708 will be set.
When does p0708 go into Fail Safe Mode?
If it receives signals that indicate two different gear positions at the same time for more than 30 seconds P0708 will be set. If this occurs twice in a row the check engine light will come on and the transmission will be commanded into “fail-safe” or “limp-home” mode.
How much does it cost to repair a p0708 Ford?
Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the P0708 FORD code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
What is the OBD code for Mercury check engine light?
Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Mercury diagnostic trouble codes. Manufacturer Specific Codes P1000OBD System Readiness Test Not Complete P1001KOER Test Cannot Be Completed P1039Vehicle Speed Signal Missing or Improper
What to look for in a Ford p0708 code?
Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. What does this mean? The cost to diagnose the P0708 FORD code is 1.0 hour of labor.
Where can I find the Mercury diagnostic code?
Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s). Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Mercury diagnostic trouble codes. Manufacturer Specific Codes P1000OBD System Readiness Test Not Complete