What does diagnostic code P0325 mean?
knock sensor 1 in
Code P0325 Meaning When the engine “knocks” there is an excessive amount of NOx that is released. When trouble code P0325 is set, this means that the knock sensor 1 in Bank 1 is not operating properly.
What does the p0325 code on OBD-II mean?
The P0325 code indicates a possible problem with your engine’s knock sensor. What exactly does it mean if your car registers this code on an OBD-II scanner and what can you do about it? Read on to find out. What Does the P0325 Code Stand For? Diagnostic trouble code (DTC) P0325 stands for Knock Sensor Malfunction (Sensor 1, Bank 1).
What are the possible causes of p0325 Chevrolet?
P0325 CHEVROLET Possible Causes 1 Faulty knock sensor 2 Knock sensor circuit poor electrical connection 3 Knock sensor harness is open or shorted 4 Faulty Powertrain Control System (PCM)
What are the symptoms of a p0325 knock sensor malfunction?
The Check Engine Light illuminating on is normally the most noticeable symptom. The engine may have a slight lack of power. There may be no felt symptoms with P0325.
How to tell if an OBD sensor is malfunctioning?
1 illuminated Check Engine Light (malfunction indicator lamp) 2 lack of power 3 engine hesitation 4 engine detonation 5 an audible pinging noise from the engine, especially while accelerating or under load 6 decreased fuel efficiency (increased consumption)
What else can cause a code p0325?
P0325 Causes. This failure code can be caused by the sensor itself, the engine controller, or the wiring between the two, including the connectors. The P0325 code could also be caused by other conditions with the engine that is causing extreme knocking; however I would consider these secondary.
What does trouble code p0325 mean?
P0325 is a general ODB2 diagnostic trouble code associated with the knock sensor circuit. This code may be seen with other knock sensor codes and lean condition codes. P0325 means that there is a malfunction within the knock sensor 1 in circuit bank 1.
What does p0305 mean?
A P0305 code means that the the car’s computer has detected that one of the engine’s cylinders is not firing properly. In this case it’s cylinder #5.
What does the p0335 code mean?
P0335 is a OBD-II generic diagnostic trouble code DTC indicating a malfunction in the crankshaft position circuit. The P0335 DTC is set once the powertrain control module (PCM) fails to detect proper sensor operation from the crankshaft position sensor.