What does CL200 on my electric meter mean?
200 Amp service
Most modern electrical meters for single family homes have the designation “CL200” somewhere on their face, which indicates they are rated for up to 200 Amp service. One can sometimes find an older house with an upgraded 200 Amp service that still has an old 15 Amp meter plugged into it.
How do I read my Itron electric meter?
The number to its left represents one hundred kilowatt-hours, the one to the left of that (the middle number) one thousand kilowatt-hours and the number second to the left of the display represents ten thousand kilowatt-hours. The number at the very left of the display represents one hundred thousand kilowatt-hours.
What is a Centron meter?
The CENTRON meter is a solid-state, single-phase residential electricity meter that provides utilities with unparalleled digital accuracy, reliability, serviceability and cost-effectiveness.
What does CL200 240V 3w mean?
The CL200 means the box is rated for up to 200A continuous 220/240V power draw through it – meaning the total load from breaker boxes, and the size of totaled main breakers, should not exceed 200A on each “side” or live lead of the 220/240V wiring – can be less.
How do I read an old electric meter?
To read correctly:
- Read the dials from left to right.
- If the pointer is between two numbers, always take the lower number.
- If the pointer falls between 9 and 0, write down 9.
- Ignore red dials, ones marked ‘100 per rev’ and the largest dial.
How do you read a Centron meter?
First the left goes on, then the middle goes on, then the right goes on, then the left goes off, then the middle goes off, then the right goes off. Kind of like a digital wheel being emulated, cute. Well, that full cycle is 6 watt-hours or to make it simpler, every time one of those dots changes it is 1 watt-hour.
How do I know what my amp service is?
Generally speaking, the lower the gauge number, the larger the wire. Inspect the electrical meter to see if it has an amperage rating. It may be printed on its face or on a label affixed to its body. Inspect your electrical panel for a label that indicates its amperage rating.
What do you need to know about the Centron?
The CENTRON incorporates a two-piece design combining a base metrology with a variety of personality modules that snap on the standard meter base. General Information Figure 1: CENTRON Personality Modules Physical Description The CENTRON meter features a common meter base to which various personality modules are attached.
How is the LCD module connected to the Centron meter?
The LCD module is connected to the metrology board using the board-to-board connector. The following information is sent to the LCD module from the metrology board: … The device connects to the CENTRON meter through a hole in the plastic inner cover located at the 12 o’clock position on the meter.
Which is the correct formula for the Centron meter?
VA (Meter) = VA (Metrology) + VA (Register) Watt Loss (Meter) = Watt Loss (Metrology) + Watt Loss (Register) CENTRON® Meter Technical Reference Guide… The following dimensional measurements are shown in inches and (centimeters).
How many digits can a Centron display roll over?
Extending from the ZRO-C2A is a cable terminating in a connector which mates to the programming connector of the CENTRON. The display may be configured for either four or five digits and will roll over at 100,000 kWh.