What does a Harley starter relay do?
The starter relay is used in an automobile application to facilitate engine starting, without running the very high current needed through the passenger compartment. This reduces the wire size and length required to deliver high current to the starter motor.
Can a bad starter relay carry a test light?
Bad starter relay that is partially making contact to read voltage with a volt meter and turn on a test light but will not carry any load.
What happens if you hit the starter button and nothing happens?
Battery good, lights , horn turn signal works. Fuel pump runs , hit starter and nothing, lights do not dim and no sound at all. All fuses O.K. starter relay maybe ? any advice ? 06 roadking by the way.
What should I do if my starter motor is out?
Like he said, most likely is your battery. However, when the hold in coil is out on the starter solenoid it will do the same thing that you are just describing. In that case you need a new starter motor or you could try to rebuild your solenoid. The starter motor and is very easy to swap out. First, disconnect your battery. Do not skip this step.
Why does my Harley Davidson make a hard clicking sound?
Clicks when trying to start does not engage. I have a Harley-Davidson 1999 sportster 1200. I get a hard fast clicking sound when trying to start. I Have put the battery on a charger and let it charge overnight. It still does the same thing. Is this a bad battery?
Why does my 1999 Road King not start?
I haveA 1999 road king have not rode it in about three years ,gas tank had treatment ,has been started and ran fine however tried to start, will start with choke on. Sprayed carburetor with carb cleaner still starts only on choke ,goes off when choke is taken off. I appreciate the post for valuable information.
Why does my Harley Davidson bike not start?
If you can start the bike this way; the start switch is probably bad, or a wire may be damaged. Let us know what you find. Sounds like you know what you are doing. You are not going to believe this – but – it was the battery in the key fob. The bike has to have a signal from the key fob before it will allow the bike to start.
Battery good, lights , horn turn signal works. Fuel pump runs , hit starter and nothing, lights do not dim and no sound at all. All fuses O.K. starter relay maybe ? any advice ? 06 roadking by the way.
What’s the voltage on a Harley Davidson starter?
I check the voltage at the kill switch and get 12.3 from the black and white wire that goes to the kill switch and the start button. But, I only get 9.2 volts from the black and red wire from the start switch to the start relay. All the fuses are good and there are 12 volts to the starter and the solenoid.