What do you need to replace a parking brake?
NOTE:To replace the brake assembly, brake shoe and lining assemblies, or other operational components the complete parking brake assembly must be removed from the vehicle. 1.Remove the parking brake assembly. 2. Remove the 4 bolts holding the yoke flange and drum. Remove the yoke flange and drive.
How to replace a GM parking brake cable?
I was able to pop the 2 cables off with no tools. Then go up front more where I could remove the one single cable to the other single cable by a link. Because the front single cable is the one getting replaced. Then release the lock pins around the cable and pull it out so it hangs straight down.
How do you adjust the parking brake lever?
LEVER STROKE 1) Remove the console box lid. 2) Forcibly pull the parking brake lever 3 to 5 times. 3) Adjust the parking brake lever by turning adjust- er until parking brake lever stroke is set at 7 to 8 notches with operating force of 196 N (20 kgf, 44 lb). 4) Tighten the lock nut. 5) Install the console box lid.
How to disassemble a transmission mounted parking brake?
Transmission Mounted Parking Brake Assembly 1.Press the plug into the output flange if plug was previously removed. Apply sealer to the lip of the plug. Press into place with the lip of the plug facing outward. The plug must be flush with the edge of the bore. Transmission Mounted Parking Brake Shoe Disassembly And Assembly =R R P 6L]HG I RU3ULQW
How do you install parking brake lever assembly?
The way to so it is install the cable and then feed it down through the floor, then bolt up the assembly. The floor grommet is designed to go in this way, not up from underneath. Hook up the hood release cable first since it’s up against the footwell wall area.
How do you replace a parking brake handle?
Push the button on the handle and put it to the floor (as you would normally disengage the parking brake). This will give you the length you need to easily hook up the rear parking brake lines to the bracket. They just slide in the slot and retain.
How do you disconnect a parking brake cable?
Disconnect the cable from the control side and follow the length of the cable to look for any guides or brackets that may fasten the cable to the vehicle body. Remove all of the supporting fasteners. Step 5: Disconnect the parking brake.
Where can I get a parking brake shoe replaced?
If you are not comfortable with performing this repair on your own, get a certified technician from YourMechanic to replace the parking brake cable and the parking brake shoe, if needed.