What causes the vibration in a Nissan Murano?

What causes the vibration in a Nissan Murano?

The Murano has rack and pinion steering, thus, no idler arm. The “jerking/vibration” that I encountered somehow was totally gone after I replaced with a new sets of sparkplug. Vibration started at 60mph x 1 week and now occurs at 45mph.

How many miles does a Nissan Murano have?

Forum for the unique Murano, and official home of Nissan Murano Club! I have a 2006 Murano SL with about 10,000 miles. I have only had it about 9 months and just love it.

Why does my car vibrate at 40 mph?

Thanks to the wealth of info, I was able to get my car back in operation with minimal cost despite being met with skepticism by the any mechanics I spoke to. Here’s the story: I had been stressing over a phantom vibration that occurred at 40 mph and above.

Is there a vibration in my Nissan Rogue?

The “jerking/vibration” that I encountered somehow was totally gone after I replaced with a new sets of sparkplug. Vibration started at 60mph x 1 week and now occurs at 45mph. Car is on stands now and I checked cv joint/axles – ok, grabbed wheels and no play on any wheel,wheel bearings ok. Front pads are low and will be replaced now.

Is the 2004 Nissan Murano a good car?

Edmunds’ expert review of the Used 2004 Nissan Murano provides the latest look at trim-level features and specs, performance, safety, and comfort. At Edmunds we drive every car we review, performing road tests and competitor comparisons to help you find your perfect car. Read the full in-depth review of the Used 2004 Murano at Edmunds.

What did I do to my Nissan Murano?

Had it welded and seat put back, power seat mechanism slips slightly Replaced radiator Replaced power steering parts Now, the car is hard pressed to go over 40mph uphill. When going over 50, drives smoothly, but unsure what the cause is…catalytic converter, fuel pump, fuel injectors, or spark plugs.

How can I get the vibration out of my Nissan truck?

3.) Take the truck out of 4-low (or jack up the front wheels) 4.) rotate the front drive shaft 180 degrees to reach the other 4 bolts and remove them. 5.) Done your drive shaft is out – put the transmission back into 2wd, and take a spin to see if your vibration is gone.