What causes hesitation and stumbling in a 1990 Chevy c1500?
An expert that got 10 achievements. Re: 1990 chevy c1500 hesitation and stumbling during… Based on what you said, I would say the engine is starving for fuel. The computer has to be disabled to set timing – there should be a procedure for that. I would start with checking fuel pressure at the throttle body.
What causes engine hesitation and stumble problems on the 90 +?
Then it developed an intermittent hesitation problem- you would be cruising at 60mph, on a 400 mile trip, ease off the gas pedal, and suddenly for 1/4 second, it was as though someone had switched off the engine and then turned it back on again. The car would then run faultlessly for the rest of the trip.
What causes a truck to stall when gas is released?
The truck idle drops and lopes and occasionally completely stalls. This usually happens when driving slow in town… backing out of parking space, letting off gas when coming to a stop sign or to park etc. It does fine to start and accelerate. I have done a tune up including oil and filter, fuel filter, spark plugs, wires, cap and rotor.
What was the cause of the stumble engine?
As with engines before the days of Electronic Fuel Injection (EFI), stumble had two basic causes- incorrect ignition and incorrect fuel/ air mixture for the required operating condition.
Why does my Chevy truck stall at idle?
Filter is not that old, and if plugged or if pressure regulator is malfunctioning, why do I never see fuel pressure at throttle body so much as waver lower than 12psi? Also, many times the lean condition will start just off idle so bad so that truck wil fall flat on its face and stall.
Why does my car stall at high speed?
The engine can stall at high speed, at low speed, or even at idle. A faulty throttle position sensor will not let your car accelerate normally. Though this doesn’t happen all the time. You may experience slow acceleration, acceleration surge at both high and low speeds, hesitation or delay in acceleration, and other related symptoms.
What is the diagnostic code for engine stall?
Diagnostic trouble codes P0120, P0121, P0122, P0123, and P0124 are what will commonly appear. The engine can stall for no reason and without any warning. This happens when the TPS gives incorrect information to the ECM. The engine can stall at high speed, at low speed, or even at idle.
What causes idle surges on a car ECM?
Idle surging can be caused due to other issues in the car, but if it happens in conjunction with other throttle position sensor symptoms, the culprit is often the TPS. At idle, the ECM will not get the correct information and the throttle will variate randomly causing idle surges.