What causes alternators to keep going bad?
Mechanically a pulley could be off-center and strain the alternator bearings. Or in older cars the tensioner may be adjusted too tightly. If it’s an electrical death, it could be using alternators from a poor source, like some of the marginal alternator recyclers.
Why does my car keep killing alternators?
It is possible that the drive belt has broken or come off the pulley, or the tensioner went bad completely. Alternators put out alternating current, and the battery needs direct current to charge, so there is a voltage rectifier that converts it, and it can suddenly go bad, too.
Can an alternator fail intermittently?
Catastrophic failures are usually due to an alternator malfunction, but can also be caused by a faulty drive belt or blown fuse. A related alternator failure is the battery warning light illuminating on a random or intermittent basis because the alternator’s carbon brushes are sticking in their holders or are worn out.
Can a bad alternator leave a Toyota 4Runner without power?
A bad alternator can leave your Toyota 4Runner without power and unable to move. Alternators don’t always go bad in the exact same way. We’ll cover the symptoms of when an alternator goes bad, and how to diagnose a bad one (which is really pretty easy).
Can a bad fuse cause an alternator to go bad?
Bad Fuse – Some vehicles use fuses to keep the alternator functional. These fuses blow out after a while or when there is a power surge. In these cases, your alternator would fail and your battery would not charge. If you have a bad alternator, look in the owner’s manual to see if there is a fuse in your car.
What should I do if my alternator does not work?
In these cases, your alternator would fail and your battery would not charge. If you have a bad alternator, look in the owner’s manual to see where the alternator fuse is in your car and check to see if it is blown. Alternators use the mechanical power of a belt and pulley to generate the electrical energy for the vehicle.
What should the voltage be on a Toyota 4Runner?
Specifically, you’ll need to set it to 20V DC. With your 4Runner turned off, you’ll connect the negative side of the meter to the negative battery post or wire. You’ll then touch the positive side of the voltmeter to the positive battery wire. With the engine off, you should get a reading somewhere between 12.0 volts and 12.6 volts.