What causes a Kia Sedona engine to leak oil?
Engine oil leaks from the front cylinder bank’s valve cover gasket. Oil drips onto the alternator, the alternator is then oil soaked & damaged resulting in the charging system becoming inoperative. The charging system warning lamp in the cluster will then illuminate.
How to remove the CVVT from a Kia Sedona?
1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the intake manifold. 3. Disconnect the CVVT oil control valve connector (A). 4. Remove the installation bolt (B), and then remove the valve from the engine. 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2.
How to install an oil control valve on a Kia Sedona?
Accurately distinguish the color of the valve and harness connectors in bank 1 and 2 when installing, otherwise the engine will operate abnormally (Refer to the table below). 1. Install in the reverse order of removal.
Is there a recall on the Kia Sedona?
This engine is manufactured by Hyundai & is the same engine design as the 2007-2012 Hyundai veracruz, which has a recall campaign #121 for this exact issue. Kia needs to implement a recall for this!. See all problems of the 2009 Kia Motor Sedona . Engine oil sensor leaking oil and engine oil light goes off and on.
How big is the oil drain bolt on a Kia Sedona?
Tighten the oil drain bolt with the 17mm socket and a 3/8″ drive ratchet to just past hand tight. If you have a torque wrench, the service manual specifies that the oil drain bolt torque specification is 26 to 33 lb-ft (35-45 Nm).
1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the intake manifold. 3. Disconnect the CVVT oil control valve connector (A). 4. Remove the installation bolt (B), and then remove the valve from the engine. 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2.
Accurately distinguish the color of the valve and harness connectors in bank 1 and 2 when installing, otherwise the engine will operate abnormally (Refer to the table below). 1. Install in the reverse order of removal.
Where is the oil filter cap on a Kia Sedona?
The engine cover is held in place by four rubber friction fasteners attached to metal pegs on the top of the engine. Locate the round black plastic oil filter cap at the right (driver) side of the engine. To remove the oil filter cap, you’ll need either a 27mm or a 1 1/16″ wrench or socket.
Why does my Kia Sedona stall when I start it?
The contact owns a 2006 kia Sedona. The contact stated that the vehicle would stall as soon as the engine was started. The vehicle was taken to the dealer where the contact was advised that the junction box and instrument panel module needed to be replaced. In addition, the engine was leaking oil into the alternator.
Engine oil leaks from the front cylinder bank’s valve cover gasket. Oil drips onto the alternator, the alternator is then oil soaked & damaged resulting in the charging system becoming inoperative. The charging system warning lamp in the cluster will then illuminate.
This engine is manufactured by Hyundai & is the same engine design as the 2007-2012 Hyundai veracruz, which has a recall campaign #121 for this exact issue. Kia needs to implement a recall for this!. See all problems of the 2009 Kia Motor Sedona . Engine oil sensor leaking oil and engine oil light goes off and on.
The contact owns a 2006 kia Sedona. The contact stated that the vehicle would stall as soon as the engine was started. The vehicle was taken to the dealer where the contact was advised that the junction box and instrument panel module needed to be replaced. In addition, the engine was leaking oil into the alternator.