What causes a DTC p0355 ignition coil E Primary?
Potential causes of a P0355 code include: Short to voltage or ground on COP driver circuit Loose connection at coil or broken connector locks Is the engine misfiring presently? If not, the problem is likely intermittent. Try wiggle testing the wiring at the #5 coil and along the wiring harness to the PCM.
What causes an OBD code of p0355?
The most common causes of the P0355 code include: A defect or fault in ignition coil B. One or more defective spark plugs. An open or shorted circuit in the ignition coil.
What are the symptoms of a p0355 DTC?
Symptoms of a P0355 DTC may include: MIL (Malfunction indicator lamp) illumination Engine misfire may be present or intermittent Potential causes of a P0355 code include: Short to voltage or ground on COP driver circuit Loose connection at coil or broken connector locks
What does DTC stand for on ignition coil?
Ignition Coil E Primary/Secondary Circuit Malfunction What does that mean? This diagnostic trouble code (DTC) is a generic powertrain code, which means that it applies to OBD-II equipped vehicles. Although generic, the specific repair steps may vary depending on make/model.
Potential causes of a P0355 code include: Short to voltage or ground on COP driver circuit Loose connection at coil or broken connector locks Is the engine misfiring presently? If not, the problem is likely intermittent. Try wiggle testing the wiring at the #5 coil and along the wiring harness to the PCM.
What does the DTC code p0355 stand for?
Diagnostic trouble code (DTC) P0355 stands for “Ignition Coil “E” Primary/Secondary Circuit.” It indicates that the powertrain control module (PCM) detected a problem in either the primary (computer side) or the secondary (spark plug side) #5 ignition coil “E” circuit.
Where does the PCM set the p0355 code?
In this system, the ignition coil goes right above the spark plug, allowing the PCM to control the ignition circuit on each cylinder directly. The PCM will set the P0355 code when it does not receive a proper pulse signal from the ignition coil.
Ignition Coil E Primary/Secondary Circuit Malfunction What does that mean? This diagnostic trouble code (DTC) is a generic powertrain code, which means that it applies to OBD-II equipped vehicles. Although generic, the specific repair steps may vary depending on make/model.