What axle does a Jeep Sahara have?
Axle Ratios: A 3.21 axle ratio is standard for the Sahara, which is lower than the 4.10 axle ratio for the Rubicon. Front Axles: While both the Sahara and Rubicon have the same rear axles, the Rubicon is equipped with a Dana 44 axle in the front as well. The Sahara has a standard Dana 30 solid front axle.
What axle does my TJ have?
TJ Wranglers will have either a Dana 30 in the front and a Dana 35 in the rear unless you have a Rubicon model. In which case you’ll have 44s front and back. Some TJs with a Dana 30 in the front can have a 44 in the rear as it was an option from the factory.
What kind of axle does a Jeep Wrangler have?
ALL TJ/LJ models come standard with a D30 front axle ALL. Picture of D30.. ALL LJ models come standard with a D44 rear ALL. Picture of D44 rear for TJ/LJ models… TJ models can have either a D35 or D44 rear axle. D35 rear picture… Optional TJ D44 rear axle picture… Exception!!!! Rubicon Models ONLY have D44 front and rear axle!.
What’s the difference between the Dana axles and axles?
The Dana 30 is once again at the front, but all Rubicon JKs will have Dana 44s in the front and rear. JL Wranglers have a Dana 30 up front and a Dana 35 in the rear. The exception as always is the Rubicon (44s front and back). What’s the Difference Between the Dana Axles?
Where is the 44 axle on a Jeep Wrangler?
Lastly, Dana’s 44 axle can be found under the front or rear end. And the differential cover on this one will not change from front to rear; consisting of flat sides and an angular top and bottom.
Do you need to replace rear neck down shafts in Jeep Wrangler?
Alloys and ARBs sounds better. Although, the stock shafts in the rear are more than is needed for 40s. They will stay stock. The front neck down shafts are getting replaced.
What kind of axles does a Jeep Wrangler have?
Most Sport and Sahara models come with an upgraded design Dana 35 in the rear and the same JK Dana 30 in the front. Rubicon’s are equipped with a new design Dana 44 in the front and rear. Revolution Gear & Axle offers Ring and Pinion Gear Sets in several different ratios for the following axle models, across all years of the Jeep Wrangler.
The Dana 30 is once again at the front, but all Rubicon JKs will have Dana 44s in the front and rear. JL Wranglers have a Dana 30 up front and a Dana 35 in the rear. The exception as always is the Rubicon (44s front and back). What’s the Difference Between the Dana Axles?
Lastly, Dana’s 44 axle can be found under the front or rear end. And the differential cover on this one will not change from front to rear; consisting of flat sides and an angular top and bottom.
When to change the axle on a jeep?
However, many jeep owners still believe swapping a new, beefier axle is more cost effective and better. As a general rule of thumb, most owners agree that once a jeep has been modified to run 32″ or 33″ tires, it is time to start thinking about upgrading the rear dana 35.