What are two important steps in putting on a seatbelt properly?
Sit upright with your hips all the way back in the seat. Step 2: Lay the lap belt across your hips. Cross the seat belt across your hips and line the belt up with the buckle. Step 3: Insert the seat belt in the buckle.
What’s the best way to replace a seat belt?
Take care to line up all the holes and then screw in the bolts as tightly as possible, before fixing in any additional bolts required to hold the shoulder strap in place. When this is fixed in place check the retractor works by pulling the belt out of place.
Where do you unbolt a car seat belt?
Depending on your vehicle, the bolts may be attached to the side of the seat, the floor or the side panel. If you have a three-point seat belt, you will have the shoulder strap, lap belt and the buckle to unbolt. If you have only a lap belt, you will only need to unbolt the belt and buckle. Unbolt all ends of the old seat belt by using a wrench.
How to install a 3 point seat belt?
Replacement Seat Belt 3 point formerly, #welr, FMVSS Federal Safety Approved Retractable Belt: CAUTION: Read these seatbelt instructions for 3 point retractable replacement seat belts thoroughly before installing this replacement safety harness.
How do you replace a WESCO seat belt?
Step # 2: Replacement: Insert the hex bolt through the (A) Retractor End of your new Wesco replacement seat belt and then screw the hex bolt into the existing anchor point (threaded hole) located on the outboard side of the vehicle near the floor as shown in Fig. 1 and tighten.
How to get a new seat belt strap?
Follow these easy steps to get a brand new seat belt strap! Pay for the seat belt strap replacement service by adding this item to your cart. Be sure to select the appropriate quantity of how many seat belts you need the strap replaced for. Mail in your seat belt (s) to us for repair. Be sure to include your receipt and mail them to: Done!
How long does it take to replace a seat belt?
Our seat belt strap replacement service is incredibly simple and fast! All you need to do is pay for the service online by checking out and then mailing in your seat belt to us. We offer a 24 hour turnaround on all seat belt strap replacements, regardless of the seat belt type. Follow these easy steps to get a brand new seat belt strap!
How do you install a bench seat belt?
Bench Seat End (20″ floppy end) 2. Bucket Seat End (11″ curved hard sleeve) Insert the hex bolt through the hole in the (E) End of the bench seat belt end as shown in Fig. 3 , and then screw the hex bolt into the existing anchor point (threaded hole) and firmly tighten.
Depending on your vehicle, the bolts may be attached to the side of the seat, the floor or the side panel. If you have a three-point seat belt, you will have the shoulder strap, lap belt and the buckle to unbolt. If you have only a lap belt, you will only need to unbolt the belt and buckle. Unbolt all ends of the old seat belt by using a wrench.