What are the tolerances for a spinning wheel?
Factory tolerances for a wheel are about .030” (30 thousandths of an inch) both lateral (side to side) and radial (up and down). Most deflections or bends outside that range will be visible to the naked eye while the wheel is spinning centered.
What to do if you don’t have enough tread in your tires?
Take a Lincoln-head penny, the kind you find in your change every day, and insert Abe’s head (head-down) into the tread. If Lincoln’s entire head remains visible, you don’t have enough tread. Take your car into the mechanic and ask about getting a new set of tires.
Can a weak spot in a tire cause a blow out?
This weak spot can cause a sudden blow out, and if you don’t put the car in the hospital (or service center, as the case may be) before this happens, it may end up putting you in the hospital when the tire blows out on the freeway. So keep your eye on those tire bulges and blisters.
What does it mean when your steering wheel is not straight?
Symptoms of steering wheel not being straight. If your steering wheel is not straight, look for these symptoms of wheel misalignment: Wheel misalignment occurs when your wheels are positioned at dissimilar angles. There might be a minor difference, but enough to cause uneven wear on your tires.
Which is better tire pressure or tire spin?
(2) Contrary to Popular Belief, More Tire Pressure is Better, to a Point. Provided the rest of the car is set up correctly, you should plant the tires with no spin, and be on your way. However, to improve your 60 foot times, up the tire pressure by .5 increments and make a new test pass until you get tire spin.
What happens when rear tires start to unload?
Once the shocks are fully extended, the only direction they can go is back down. Once the shocks start collapsing, the rear tires start to unload. What can happen is that the front end will rise quickly and get traction but then the front end starts to settle.
What to do if your power wheels are not working?
If you tightened the motors using a power drill take them back out, put threadlock on the screws, and hand tighten the motors. 6. Check your rear axle for even the slightest bend. Roll it on a flat surface. This problem can also shred final gears, third gears, and gearbox housings.
What happens when you break the Power Wheels?
This is done by raising the back of the car in the air and running it in low speed for the time listed on the manufacturer’s instruction sheet. Failure to break them in causes excessive arching/sparking in the motor and will crack a motor brush.