What are the parts of a mortice lock called?
The parts included in the typical US mortise lock installation are the lock body (the part installed inside the mortise cut-out in the door); the lock trim (which may be selected from any number of designs of doorknobs, levers, handle sets and pulls); a strike plate, or a box keep, which lines the hole in the frame …
What are the parts of a lock called?
Parts of a door lock
- Trim: Sometimes called a rose, the trim is a decorative plate attached to the door under the knob or lever.
- Deadbolt:
- Escutcheon:
- Faceplate.
- Backplate:
- Latch bolt:
- Spindle:
- Strike plate:
What is a door latch and strike?
The latch is the small metal bolt that you will see sticking out of the side of the door when the door is open. The door strike is fastened, usually by screws, onto the frame of a doorway, and it is carefully aligned with the lockset in order to give the latch a place to sink into when the door closes.
What is a strike plate?
Strike Plate This is the plate the latch-tongue, or deadbolt-tongue will connect with. It should sit flush with the door jamb. Any passage or privacy set needs to have a strike plate for the door to latch. Additionally, deadbolts need a strike plate to properly lock.
How do you fill a mortise lock hole?
Mortise Locks If you’ve recently replaced a mortise lockset with a traditional doorknob, the extra holes will remain on the interior and exterior sides of the door, and a rectangular recess will remain on the edge of the door. Mortise locksets and doorknob assemblies can differ according to manufacturer.
What is a strike lock?
What are Electric Strike Locks? Electric strike locks are electromechanical door locking mechanisms. These locks enable you to release the locked latch or bolt on a given door from the outside (using a key card, key pad, or other electronic access key).