What are the installation instructions for a torque converter?
Torque Converter Installation Instructions. After bell housing bolts are tight, check free movement of converter. It should have 1/16 to 1/8″ (ON GM ONLY) of clearance between pads on converter and flex plate. If you have more than 1/16 to 1/8″, install equal thickness washers to reduce clearance to 1/16 to 1/8″ (ON GM ONLY).
Do you need to remove transmission on Nissan Pathfinder?
The process to remove the transmission assembly is very similar for both the two- and four-wheel-drive Nissan Pathfinder models. You remove the transmission and transfer case as a single assembly on your 4WD. This makes it necessary to use a suitable transmission jack on this model.
What should clearance be between flex plate and torque converter?
After bell housing bolts are tight, check free movement of converter. It should have 1/16 to 1/8″ (ON GM ONLY) of clearance between pads on converter and flex plate. If you have more than 1/16 to 1/8″, install equal thickness washers to reduce clearance to 1/16 to 1/8″ (ON GM ONLY).
How big of a washer do I need for torque converter?
It should have 1/16 to 1/8″ (ON GM ONLY) of clearance between pads on converter and flex plate. If you have more than 1/16 to 1/8″, install equal thickness washers to reduce clearance to 1/16 to 1/8″ (ON GM ONLY).
Torque Converter Installation Instructions. After bell housing bolts are tight, check free movement of converter. It should have 1/16 to 1/8″ (ON GM ONLY) of clearance between pads on converter and flex plate. If you have more than 1/16 to 1/8″, install equal thickness washers to reduce clearance to 1/16 to 1/8″ (ON GM ONLY).
The process to remove the transmission assembly is very similar for both the two- and four-wheel-drive Nissan Pathfinder models. You remove the transmission and transfer case as a single assembly on your 4WD. This makes it necessary to use a suitable transmission jack on this model.
After bell housing bolts are tight, check free movement of converter. It should have 1/16 to 1/8″ (ON GM ONLY) of clearance between pads on converter and flex plate. If you have more than 1/16 to 1/8″, install equal thickness washers to reduce clearance to 1/16 to 1/8″ (ON GM ONLY).
It should have 1/16 to 1/8″ (ON GM ONLY) of clearance between pads on converter and flex plate. If you have more than 1/16 to 1/8″, install equal thickness washers to reduce clearance to 1/16 to 1/8″ (ON GM ONLY).