What are the fault codes on the Fuso Fighter 6M60?
Output from the atmospheric pressure sensor is too low. Output from the atmospheric pressure sensor is too high. Output from the intake air temperature sensor is too low. Output from the intake air temperature sensor is too high. Output from the coolant temperature sensor is too low. Output from the coolant temperature sensor is too high.
How to erase diagnosis code on Mitsubishi 6m70?
• Open the memory clear switch and reconnect it; all diagnosis codes stored in electronic control unit memory will be erased. To cancel diagnosis code erasure after opening the memory clear switch, turn the starter switch to the OFF position and then reconnect the memory clear switch.
What are the hexagon flange nuts in a Mitsubishi 6m70?
Hexagon Flange Nuts (Unit: N·m {kgf·m}) Strength 4T Identification symbol TABLE OF STANDARD TIGHTENING TORQUES Tightening Torque for General-Purpose Flare Nut (Unit: N·m {kgf·m}) Pipe diameter Tightening torque
How to reconnect memory clear switch Mitsubishi Fuso?
Reconnect memory clear switch to erase DTCs. 3. Mitsubishi Fuso: Diagnostic Trouble Code Interpretation Control unit turns light off for 2.4 seconds after diagnosis and displays the code. The first digit of code illumination for 1.2 seconds and turns off for 1.2 seconds.
Do you need a fuse for a fused disconnect?
Since fuses are not always required at the disconnect, the disconnect and fuse makers often sell solid metal blanks to use in place of fuses. Fuses have two advantages over circuit breakers.
Where is the Diagnostic Code Switch on a Mitsubishi Fuso?
With diagnosis switch removed, remove Memory Clear Switch, warning lamp will start flashing codes, record codes. The memory switch is also located at rear of relay and fuse box. Reconnect memory clear switch to erase DTCs. 3. Mitsubishi Fuso: Diagnostic Trouble Code Interpretation