What are the error codes for Master Spa?
Please note that the Balboa Error Codes cover all circuit board manufactured by Balboa including Cal Spa, Marquis Spa, Master Spa and many others. Gecko Error Codes also cover any control box manufactured by Gecko. Overheat. Spa has shut down. One sensor has detected 118º F at heater. Overheat. Spa has shut down. One sensor has detected 110º F.
What does a c1101 trouble code mean on a car?
A C1101 trouble code indicates that the vehicle’s Engine Control Unit (ECU) has detected an unspecified failure in the Antilock Braking System’s (ABS) hydraulic valve circuit. The ABS system is a featured in modern vehicles, used to minimize the risk of losing control while making hard turns or driving on rugged surfaces.
Are there any error codes on my hot tub?
A comprehensive list of spa & hot tub touchpad (also referred to as spaside or topside control panel) error / fault codes, operational messages and reminders to suit practically all spas that have ever been made and sold throughout the world are listed here and for download also.
What does it mean when your spa sensor is out of balance?
Sensors out of balance. If alternating with temp, may be temporary condition. If display shows only this message (blinking) spa is shut down. Substantial difference between temperature sensors detected. Could indicate a flow problem. Persistent low flow problems. (Displays on the 5th occurrence of “HFL” message with 24 hours).
What is the error code for the spa?
PSoL = Pressure switch open with low pump. PSoH = Pressure switch open with high pump. ToE = Time out error. Rare system error. Spa unusable. Contact ACC. OHH = Overheat. Spa has shut down. One sensor has detected 118º Fat heater. OHS = Overheat. Spa has shut down. One sensor has detected 110ºF. SnA = Spa is shut down.
What does Flo stand for in a spa code?
FLO* = Flow Switch (heater is deactivated. Pump may also be deactivated). Hold = Panel sensors have been pressed too many times in a short period of time. HOT = Circuit Board temperature has exceeded acceptable limit.
When to use Spa when temperature is flashing?
Do not use spa when temperature is flashing or the OH message is displayed. HLoH = Hi Limit Over Heat. Hi limit sensor is disconnected or shorted or the spa temperature is above 112° F. SEoP = Sensor open or disconnected. Heater disabled but the spa is operational.
What does p0016 mean on an ECM?
It does this by monitoring them using the Camshaft Position Sensor (s) and Crankshaft Position Sensor. If the Engine Control Module (ECM) detects that the bank 1 intake camshaft and crankshaft are not in the correct position, it will trigger code P0016.