What are the end caps on a camshaft?
The stud and nut arrangement on the end caps (1 and 7) allows rocker arm shaft removal without disturbing the gasket eliminator seal from the end camshaft caps to the cylinder head. There are four different camshaft cap configurations.
What do you use to remove rocker arm shafts?
Use rocker arm and shaft assembly removal tool (J–35996-A) to remove the rocker arm shafts, with rocker arm assemblies in place. See Figure “Rocker Arm Shaft Assembly Removal” . Note: Some engines may be equipped with ceramic injector rollers. Use extra caution while removing and handling.
How to remove stock rocker arms on m-6564?
Step 1:Remove valve covers. Rotate engine to number 1 cylinder TDC. The distributor rotor should be at the number 1 terminal. Step 2:Remove stock rocker arms, fulcrums and bolts from number 1 cylinder. Clean pedestal mounting surface. Remove pushrods; clean, oil and reinstall. Make sure the pushrod is in the lifter seat.
Where is the exhaust rocker arm assembly located?
In each set of rocker arm assemblies, the exhaust rocker assembly is the widest, straddling the intake and fuel injector rocker arm assembly. The center rocker operates the fuel injector follower. See Figure “Rocker Arm Identification” . Figure 2. Rocker Arm Identification
The stud and nut arrangement on the end caps (1 and 7) allows rocker arm shaft removal without disturbing the gasket eliminator seal from the end camshaft caps to the cylinder head. There are four different camshaft cap configurations.
How big are LS cyl.shaft mounted rockers?
After all of the rockers have been tightened down, set valve lash and torque the adjuster screw jam nuts to 15-20 ft-lbs. On LS cyl. heads with 8mm stand bolts torque to 25-28 ft. lbs. WARNING TO INSTALLER
Where are the rocker arms on a Cobra Jet engine?
The 429 Cobra Jet utilizes fulcrum-style rocker arms that are retained on individual studs in the cylinder heads via locking nuts. Other Lima series engines have a rail-style rocker arm assembly that bolts directly to the head.
Where is the camshaft located on a car?
The Series 60 camshaft is located on top of the cylinder head, just below the valve cover. The camshaft actuates the intake and exhaust valves and injector operating mechanism. See Figure “Camshaft and Related Parts” .