What are the disc brakes on a 1995 Buick Regal?
The rear disc brakes on the 1995 Regal have calipers, pads, and rotors similar to the front disc brakes. Remove the initial torque from the rear wheel lug nuts, using a tire iron. Do not remove the lug nuts completely, but turn them so they are unstuck (3/4 turn). Lift the rear of the Buick using a 2-ton jack or a jack with greater capacity.
How do you change the brake pads on a Buick LeSabre?
Install the new inboard brake pad and shim into the caliper piston bore by pressing the retaining clips into the bore until it locks into place. Install the outboard pad onto the caliper housing, making sure to align the retaining clips into the holes in the caliper. Use the screwdriver to convince the clips onto the caliper if necessary.
How do you install rear wheels on a Buick Regal?
Install the rear wheels on the Regal after you have installed and torqued both rear brake calipers on the vehicle. Snug the lug nuts onto the wheel studs, using a tire iron. Lift the rear of the Regal off of the jack stands, and remove the jack stands from beneath the Regal.
How do you remove the caliper from a regal?
Remove the lug nuts completely with a tire iron, then remove both rear wheels from the Regal. Remove the rear caliper mounting bolts on one side of the Regal. Use a 3/8-inch ratchet to turn the caliper bolts counterclockwise until they are removed. Remove the caliper from the brake assembly, using a pry bar to gently pry the caliper off.
What kind of brake pads do Buick Regals have?
The fifth-generation Buick Regal might seem like an easy car to repair on the surface when the pads need replacement, but if you assume that this is just another Buick, you could quickly find yourself in trouble. There are two brake packages for the Regal. Base models have a single-piston caliper in the front.
How do you replace the caliper bracket on a Buick Regal?
In order to reinstall the caliper bracket, you need a torque angle gauge and two new caliper bracket bolts. The bolts are torque-to-yield (TTY) fasteners that stretch. TTY fasteners are mounting fasteners that are torqued beyond the state of elasticity and, therefore, undergo plastic transformation. This causes them to become permanently elongated.
How do you change the brake pads on a car?
New brake pads should always be greased at their contact points, in addition to greasing the caliper guide pins and replacing the brake pad hardware, if applicable. Once the caliper has been compressed, you can then replace the caliper and caliper bolts, bleed the brakes, and replace the wheel.
How does HiPer Strut change Sia on Buick Regal?
The HiPer strut changes the SIA, or “king-pin angle,” so the angle to the tire’s centerline is less. They do this by placing two ball joints on the end of the strut. In order to reinstall the caliper bracket, you need a torque angle gauge and two new caliper bracket bolts.