What are the brake codes on my Infiniti?
The two codes that come up are p2136 and p2128. The brake fluid is fine. These lights are on all the time is not when I drive the car. I can leave the car siting for a few minutes and then start it back up.
What kind of issue is my Infiniti having?
My Infiniti Is Having An NOT ACCELERATING PLEASE HELP! My Infiniti is having an accelerating issue that I cant find out what the issue is.
What to do if your Infiniti is not accelerating?
The APP that you replaced is actually 2 sensors. What I need you to do is start by checking the connection on the APP to make sure nothing is damaged or out of place. If all looks good, start with sensor one. Unplug the connector at the APP and check voltage between terminal 6 and ground. (Do not use the ECM ground). Voltage should be around 5v.
Why is the gas pedal not working on my Infiniti?
There is no misfire or lack of power other then the throttle body not opening. I also replaced the sensor on the gas pedal. There is times when I do start it and it revs up great like it should you put it in gear and it responses like it should with just a small tap to the accelerator. But just after a few second its goes back doing the same thing.
What is an OBD-II trouble code on a car?
What is an OBD-II Trouble Code? On-Board-Diagnostic (OBD) trouble codes are one way your vehicle communicates with a mechanic. Every car built since 1996 has an OBD computer system that monitors and identifies issues. In particular, it looks for issues that may result in harmful and polluting emissions from exhaust gases.
Where is the diagnostic trouble code located on an Infiniti Q45?
On J30, M30 and Q45 models, the ECU is located behind the RH kick panel. If a malfunction occurs within the ECU/fuel injection system, a diagnostic trouble code may be stored in the ECU and the ‘‘Check Engine’’ lamp will blink. There is also a lamp built into the ECU which will concurrently blink. To read Code output, proceed as follows:
Where to find check engine light codes in Infiniti?
These are listed in numerical order for easy searching. When retrieving Infiniti check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.
How to read a malfunction code on Infiniti?
Wait two seconds, then rotate switch to full counterclockwise position. A malfunction code can be read as the long (0.6 second) blink, indicating the first digit of a two digit number and the short (0.3 second) blink, indicating the second digit.
Where is the diagnostic mode switch on Infiniti?
A second, though more time consuming method of clearing Codes involves using a small screwdriver to turn the diagnostic mode selector switch, located on the side of the ECM/ECU, fully clockwise. After waiting two seconds, rotate the switch to the full counterclockwise position.
Why is my Infiniti not accelerating at normal rpm?
I figure that the issue was the throttle body, I replace it and know it starts up fine all the time at its normal RPM but it still has the problem of not accelerating.
What should the voltage be on my Infiniti?
(Do not use the ECM ground). Voltage should be around 5v. If that is not good, check wiring harness for shorts or open circuits between ECM and APP. If good, check sensor 2 the same way but via terminal 4. Voltage should also be around 5v.