What are some common problems with the Isuzu Rodeo?
Customers reported these issues on Isuzu Rodeos during the course of the entire manufacturing production of the vehicle from 1992 through 2004. Another common issue is build-up of debris in the rear differential, leading to noise and differential failure.
Can you transfer from 4L to 2WD in an Isuzu Rodeo?
If you’re transferring between 4H to 4L or from 4L to 4H I reccomend that you do so at a slow speed of about 1-5 MPH or do it stopped. You cannot however take it from 4H or 4L to 2WD mode while the vehicle is in motion.
Why is my Rodeo 4 wheel drive not engaging?
My ’04 rodeo 4WD won’t engage. When I turn the switch, nothing happens. No dash light, clicks, noises or anything. Also, the ABS light recently came on.
Can you take a 4H rodeo to 2WD?
You cannot however take it from 4H or 4L to 2WD mode while the vehicle is in motion. You must stop the vehicle, place the 4WD selector into 2WD place the transmission in reverse about 3-5ft and then you’re good to go forward again. You can go forward without going in reverse, however the 4WD will still likely be engaged.
How to get a 4WD on an Isuzu Rodeo?
Unable to clear the light using diagnostic scan tool.while the light is on you will not be able to select 4wd, the first step is to try and reset the Transfer Case Control Module. 2 Remove the drivers front seat or console wherever it is located. On the 2004 Rodeo it is under the front part of the console.
What kind of control unit does a rodeo use?
The 2003 – 2004 Rodeo’s use 4WD control unit (Part # 8-97351-959-1). The 1998 – 2002 4WD control module has a single 16 pin connector and a single cable. The 2003-2004 control unit has a 20 pin connector, a 16 pin connector and two cables.
Where is the green light on the rodeo 4×4?
Yes this model has an indicator light to tell if the 4X4 is engaged. It is a green light that is at the bottom middle of the instrument cluster. The correct way to change from 2WD to 4WD is to STOP the vehicle, put the trans in neutral and then put your vehicle into 4H or 4L.
Where is the transfer case actuator located on the Isuzu?
It appears you have a problem involving the transfer case. Make sure the transfer case actuator is plugged in and that the 4WD control module connector located under the center console is plugged in. Also, when you depress the 4WD switch you can hear the case actuator operate if it is receiving a drive signal from the 4WD control module.