Is there check engine light, no other problems?
EDIT: No check engine light, no other problems. 1. From a full stop, slams into gear. Once in a while at a stop light, when I press the gas, the car hesitates for a moment and then slams into gear. The entire car jolts very hard. This happens maybe a couple times a week at worst (or not at all for weeks).
Why does my Chevy transmission not go into 3rd gear?
Chevy transmission won’t shift, stuck in 1st gear or limp mode – Speedometer may also display zero at all times. It could be internal transmission failure, low transmission fluid, or faulty Vehicle Speed Sensor (VSS sensor). Chevy transmission won’t go into 3rd or 4th gear – This is a good indication that 3 or 4 gear clutches are worn.
Why is my Silverado not shifting into higher gears?
Not shifting into higher gears – 2009 Chevrolet Silverado… I put the vehicle in drive it will go and make it s first gear shift, however as I progressively get going faster the engine will rev up, the oil gauge spikes up and it doesn’t shift, I let off the accelerator and it will shift.
How to troubleshoot a transmission problem in a Chevrolet?
1 Symptoms. The first sign that you may have a possible transmission problem could be the check engine light coming on. 2 Troubleshooting Steps. The first steps in troubleshooting the Chevrolet transmission problem are to read the fault codes from the Transmission Control Module (TCM) and check the transmission fluid level. 3 Common Problems. …
What causes a flashing check engine light on a GMC Sierra?
While a majority of the time, the flashing check engine light is going to be caused by a misfire related to your Sierra’s ignition system or fuel system (as stated above), there are other issues that can cause it. Your timing chain could have jumped .
Why does my check engine light keep coming on?
The Check Engine light will also come on if your mass airflow sensor fails This can happen if your air filter has not been replaced on a regular basis. If this is the problem and you continue to run your vehicle with the Check Engine light on and the airflow sensor is failing, you’ll be creating more problems.
How often should I Change my Check Engine light?
Spark plugs should be replaced approximately every 25,000 miles to prevent their eventual failure. A diagnostic test can determine if the spark plugs are the reason the Check Engine warning light has come on. Our Cardinale GMC Service technicians can replace your spark plugs and reset your vehicle’s computer.
Not shifting into higher gears – 2009 Chevrolet Silverado… I put the vehicle in drive it will go and make it s first gear shift, however as I progressively get going faster the engine will rev up, the oil gauge spikes up and it doesn’t shift, I let off the accelerator and it will shift.
Why does my car Jerk when I Turn on the ignition?
Of course, if the fuel can’t become ignited, then the car won’t start. The reason why your car is jerking during ignition is because a car has as many spark plugs as it does fuel cylinders. Some of them may work, but the ones which don’t cause the car to jerk.
Why is my Check Engine light flashing and car shaking?
If your car’s control system discovers problems that it cannot handle, the check engine light will turn on. In addition, the computer will have a trouble code stored in the memory. The code’s main function is to determine the origin of the problem. To read the code, you will need a diagnostic computer or an electronic scan tool.
Why does my car JOLT at a stop light?
Once in a while at a stop light, when I press the gas, the car hesitates for a moment and then slams into gear. The entire car jolts very hard. This happens maybe a couple times a week at worst (or not at all for weeks). When it first started it would happen like once every 3 months or so.
When to worry about Intermittent check engine light?
Typically an intermittent check engine light concern happens under very specific conditions such as when it’s hot, cold, damp or driving over bumps. Knowing this information can greatly reduce the time it takes to locate the source of the fault. The first thing we need to do is duplicate the concern.
Of course, if the fuel can’t become ignited, then the car won’t start. The reason why your car is jerking during ignition is because a car has as many spark plugs as it does fuel cylinders. Some of them may work, but the ones which don’t cause the car to jerk.
How to reset the Check Engine light on your car?
How to Reset the Check Engine Light. 1 Drive Till it Turns Off. This is the easiest way. Your vehicle’s sensors will generally recheck the problem that led to the CEL. If you’ve fixed the 2 Turn the Car Off and On 3 Times. 3 Disconnect and Reconnect the Battery. 4 Use an OBD Reader.
What happens if your car jerks while driving?
You may even notice your car engine light has come on to warn you of an issue. Jerking movements while driving can be very dangerous, leading not only to vehicle damage, but also the potential for serious road accidents. Getting to the problem at the first symptoms can avoid more serious break-downs.