Is there a way to reset an aftermarket car alarm?
Be patient and the alarm will reset itself. Wait for the alarm to reset. Once the alarm resets it will still be armed, but will not be activated. Turn the key to the “on” position. This will disarm your alarm, effectively resetting it. I have an after-market car alarm.
Why does my car alarm keep going off?
It is possible that the key fob or alarm remote has failed and is not sending a proper signal to your vehicle’s alarm system. When this happens, your vehicle’s alarm may inadvertently end up going off without you wanting it to. Step 1: Consult your manual.
Where is the fuse box for a car alarm?
Locate the appropriate fuse box. Most modern vehicles have more than one fuse box located throughout the vehicle for various electronic components. Use the vehicle’s owner’s manual to identify the box with the fuse powering your factory car alarm. The fuse box may be located in the engine bay or the cabin of the car.
How can I disable the alarm on my car?
Turn the key quickly from the “Run” position to the “Off” position five times. Turn the key to the “Start” position and start the car. This will disable the alarm and allow you to start the car again.
How can I find out if my alarm box is the alarm?
Locate the alarm module; a black, rectangular box about the size of a human palm. A good way to be sure the box is the alarm is to locate a small, stiff wire that extends from one end. This is the antenna wire that picks up the signals from the key fob.
Are there any problems with aftermarket car alarms?
Aftermarket Alarm and Keyless Entry problems and solutions. If you have an old aftermarket alarm or remote start system installed in your car then chances are you may be experiences alarm problems. The main problem with aftermarket alarm systems is eventually they break.
Why does my after market alarm keep going off?
Poorly supported aftermarket alarms make finding a replacement fob challenging. They’re also problematic because ignition wires are cut during the installation process, often leading to no-start conditions when done improperly. Alarms can also go off for no apparent reason, yet another annoyance.
How do you repair an after market alarm?
Snip the wire out of the circuit, repair the splice with a new wire crimp, and tape the repair with electrical tape. Reconnect the battery and start the car. If there is a problem in starting, double check the ignition wire repair and make sure the repair is sound. Some alarm installations include a separate alarm horn mounted under the hood.