Is there a 2009 MaxxForce 9 engine with no start?
I need help with an 2009 maxxforce 9 engine with a no start. Last week it started cranking longer but it started. About I need help with an 2009 maxxforce 9 engine with a no start. Hi there. My name is Andy ! Can we star with the last 8 digits of the vin number please ? 9H158127 are the last 8 digits.
What makes an international MaxxForce DT No start?
Sounds different when cranking as well. Will not even start on starting fluid, not even a little bit. It does not build oil pressure while cranking. Codes are engine exhaust valve actuation system oil pressure, brake switch, and engine turbocharger 1 outlet pressure. SPN 4287, SPN 5541 and SPN 597.
Why is my MaxxForce crank but no start?
I also heard that using cheap fuel filters causes issues. They are all expensive and hard to find American made filters. Foreign made junk should cost end users less but it usually cost you more in other areas. Like a cheap air filter that a contractor installed. It somehow got rain water intrusion and sucked part of the filter into the engine.
How to raise red lock on MaxxForce 9 engine?
The red lock needs to be raised, then you should use a blow gun to clean out any debris that may have gotten into the sides of the connector. Then squeeze the black tab that is in front of red lock and pull up . They are quite difficult to get undone.
Why does my MaxxForce DT engine not start?
Initially though it was a HP oil issue and replaced the ICP and IPR. Still have a crank no start. no codes pulled and on the live data while cranking the highest oil pressure reading was 1700psi and supply fuel was 73 psi. the engine will jump once like it wants to start when the oil pressure is at it highest but goes back to just cranking.
When to shut down international MaxxForce DT No start?
Its not supposed to until you fire it up. Then the oil pressure is required to be past 25 to whatever value it likes within 8 seconds of a successful start. If not you need to shut down and check for problems.
Where is the ICP on a no start MaxxForce DT?
HAS LOW INJECTION PRESSURE-54PSI WITH A DESIRED OF 900PSI, CAN SOMEONE GIVE ME THE ICP LOCATION, UNDER THE VALVE COVER MAYBE? ANY IDEAS TO SPEED UP MY DIAG
Why is my no start MaxxForce DT not starting?
Not building icp pressure can be a few different issues. First, engine oil runs the high pressure side. Make sure you have oil in it. Then, for what ever reason it cannot build high pressure. Either there is a massive leak, pump failure, IPR failure or simple ICP sensor failure. Most common are the connector right at the IPR.