Is the twist grip sensor compatible with the TGS?
Discussion in ‘ Touring Models ‘ started by ChopperDoc, Nov 24, 2011 . If you are extending the wiring on your TBW Touring bike, you will notice that the Twist Grip Sensor (TGS) wiring for HD # 32310-08 does not match up to your existing TGS wiring.
When to stop pulling the twist grip sensor?
When the TGS is about two inches from being seated – quit pulling and push the sensor the rest of the way in. This leaves some slack in the buncle inside the bars. Thanks Chopper Doc, I just started tearing my bike down to install the new twist grip sensor and realized the wires are not the same color code as the factory wires.
Can a twist grip sensor be installed on a trike?
The Twist Grip Sensor Kit enables installation of accessory handlebars on vehicles equipped with throttle-by-wire. Fits ’08-’13 Touring models (except Trike) equipped with internally routed switch-wires. Fits with either stock or accessory handlebars. Installation Instructions can be found with the appropriate handlebar.
How does a twist grip sensor work on a Harley Davidson?
I recommend that you pull the switch housing wiring through first, then apply a thin coat of dielectric grease to the TGS bundle. Gently pull the bundle through the bars while pushing from the TGS end. When the TGS is about two inches from being seated – quit pulling and push the sensor the rest of the way in.
Discussion in ‘ Touring Models ‘ started by ChopperDoc, Nov 24, 2011 . If you are extending the wiring on your TBW Touring bike, you will notice that the Twist Grip Sensor (TGS) wiring for HD # 32310-08 does not match up to your existing TGS wiring.
When the TGS is about two inches from being seated – quit pulling and push the sensor the rest of the way in. This leaves some slack in the buncle inside the bars. Thanks Chopper Doc, I just started tearing my bike down to install the new twist grip sensor and realized the wires are not the same color code as the factory wires.
The Twist Grip Sensor Kit enables installation of accessory handlebars on vehicles equipped with throttle-by-wire. Fits ’08-’13 Touring models (except Trike) equipped with internally routed switch-wires. Fits with either stock or accessory handlebars. Installation Instructions can be found with the appropriate handlebar.
I recommend that you pull the switch housing wiring through first, then apply a thin coat of dielectric grease to the TGS bundle. Gently pull the bundle through the bars while pushing from the TGS end. When the TGS is about two inches from being seated – quit pulling and push the sensor the rest of the way in.