Is the Eaton Super 10 a manual transmission?
Operating a heavy-duty commercial vehicle with Eaton’s Super 10 manual transmission. Includes information on proper shifting. Operating a heavy-duty commercial vehicle with Eaton’s Super 10 manual transmission.
What kind of transmission does Eaton Lightning have?
It contains technical details on the new Eaton Fuller Lightning “FRLO-1X410C-T2 series model transmission. Information contained within this manual was accurate at the time of printing. However, you shoul d contact your Eaton Fuller Engineering representative prior to start of engineering for a new application. Transmission Features
How much torque does an Eaton Fuller transmission need?
Eaton Fuller requires that transmission input torque spikes, due to drivetrain torsion- als, must be less than 300 lbs. ft. above the nominal transmission input torque rating for engine speeds above 1000 rpm and vehicle road speeds above 20 mph. Vehicle Air Supply Requirements
Where is the splitter button on an Eaton transmission?
The splitter button on shift knob selects one of two available ratios in each lever po sition except the lo wer right position. That position automatically will shift between the top two gear ratios. The shift pattern instruction label for this Lightning series transmission is available as Eaton Fuller part number 5586257. Weight
What causes a slipout on an Eaton Fuller transmission?
Under the right conditions, slipout will result. Some of these conditions are: Transmission mounted eccentrically with engine flywheel pilot. Excessive gear clashing which shortens clutching teeth. Incorrect adjustment of remote shift control linkage resulting in partial engagement. Also check for loose connections and worn bushings.
What causes vibration in an Eaton Fuller transmission?
Although the effects of vibration will show up in the transmission, vibration usually originates somewhere else in the drive train. Vibration can usually be felt or heard by the driver; however, in some cases, transmission damage caused by vibration will occur without the driver’s knowledge.
Is the escape key closed on the Eaton Super 10?
This modal can be closed by pressing the Escape key or activating the close button. Operating a heavy-duty commercial vehicle with Eaton’s Super 10 manual transmission. Includes information on proper shifting. Operating a heavy-duty commercial vehicle with Eaton’s Super 10 manual transmission. Includes information on proper shifting.
What are the problems with an Eaton Fuller transmission?
Oil level too low or too high, wrong type of oil, or an operating angle of more than 12 degrees. 2. Operating consistently under 20 MPH. 3. High engine RPM. 4. Restricted air flow around transmission, due to the transmission being “boxed in” by frame rails, deck lids, fuel tanks and mounting brackets, or by a large bumper assembly.
What makes Eaton Fuller air system so good?
• Exhaustive comparison testing has shown genuine Eaton® Fuller® air system components lasting up to three times longer than will-fit products. • Made from materials chosen for long and satisfactory performance, unlike cheaper or easier to manufacture materials typical of non-genuine replacements.
What are the speeds of a Fuller transmission?
A-5510 A-5015 Blue Deep Reduction Valve 14651 A-4900 Red A-5013 Gray Three Position Selector WHEN IN LOW RANGE SHIFT ONLY DO NOT PRE-SELECT OUT IN D E P R ED U C T I O N E Gray 8, 9, and 10 Speeds 8LL, 15, 6613 Speeds RTLO-10 Speeds RT/RTLO 13 Speeds RTLO-18 Speeds General Information 5 General Information