Is the 1998 K 1500 hard to start?
Not open for further replies. i am working on a 1998 k 1500 5.7 the truck is very hard to start but when it does it runs fine.. good power and will start fine afterwards,,the problem i am having is when it sits for 2 days then once again it is very hard to start…
How to troubleshoot a no start GM 4.3L pick up?
Testing a Cranks but Does Not Start condition on your GM 4.3L, 5.0L, 5.7L pick up, van or SUV is not that hard to do, if you have a solid diagnostic strategy. In this article I’ll show you the basics of testing such a problem.
Can a 1999 Chevy c1500 / k1500 start?
Hi, our 1999 CHEVROLET C1500/K1500 is having the same issue. After sittiing for a few hours, we have to crank it and eventually put a little gas or tarting fluid in the throttle body for our truck to start but runs and drives fine once it does start and will start right up after only sitting for about an hour or so. 205 people found this helpful.
How does a PassLock work on a 98 Chevy?
On the 98 the passlock is a module in the column and the key switch goes inside it. There is a contact inside this module that reacts to a change in magnetic field when the key switch is turned. There are three wires that come off the top of the module.
Is the 1998 Chevy Silverado 5.7L hard to start?
Hello all, My 1998 chevy silverado 5.7L Vortec used to start as soon as you bump the key, and now it is hard to start (mainly when its cold) it takes several cranks of the engine to start and after truck warms up its okay, usually in the morning or if the truck sits for several hours after running. (i.e.
Hi, our 1999 CHEVROLET C1500/K1500 is having the same issue. After sittiing for a few hours, we have to crank it and eventually put a little gas or tarting fluid in the throttle body for our truck to start but runs and drives fine once it does start and will start right up after only sitting for about an hour or so. 205 people found this helpful.
On the 98 the passlock is a module in the column and the key switch goes inside it. There is a contact inside this module that reacts to a change in magnetic field when the key switch is turned. There are three wires that come off the top of the module.
Not open for further replies. i am working on a 1998 k 1500 5.7 the truck is very hard to start but when it does it runs fine.. good power and will start fine afterwards,,the problem i am having is when it sits for 2 days then once again it is very hard to start…
Is the warrior Idles fine when trying to accelerate?
The warrior idles fine. I’ve adjusted to air mix screw back and forth. It changes the idol but doesn’t seem to improve things when I try to rev it up. 2.25 turns seems to be the sweet spot, as far as idol. The needle is where zoom put it.
How long does it take to fire a hard start Chevy?
Good Morning island auto, well your mention of that kind of pressure does sound a bit high, but the gauge you are using may have an error, generally even if the fuel did drain back to the tank it only takes a few seconds to be replenished and even if the system contains air, I would expect some firing to happen initially.