Is it hard to start a 1988 L98 auto?
1988 L98 Auto. recently aquired. hard to start from cold start. literally 3-7 seconds on the starter. New wires, not plugs. new cap and rotor. trust me being a Jeep guy I know oil smoke smell. Once she is running, she starts slow then idles fine. after that no performance issues.
Is it hard to start, when cold starting?
Click Here to Register for Free! 1988 L98 Auto. recently aquired. hard to start from cold start. literally 3-7 seconds on the starter. New wires, not plugs. new cap and rotor. trust me being a Jeep guy I know oil smoke smell. Once she is running, she starts slow then idles fine. after that no performance issues.
What is the rating of the cold start injector?
Average rating from 141 customers who received a Car is hard to start Inspection. The cold start injector, also referred to as the cold start valve, is an engine management component found on many road going vehicles.
Can a weak F pump cause a cold start?
I also like the idea of checking the 9th injector used on the one or two year corvettes, this injector will cause the exact same symptom as a weak/bad F Pump or inoperative relay. This injector is sometimes referred to as a “Cold Start Valve” also called a “Cold Start Injector”. Very popular item in many systems made by Bosch.
1988 L98 Auto. recently aquired. hard to start from cold start. literally 3-7 seconds on the starter. New wires, not plugs. new cap and rotor. trust me being a Jeep guy I know oil smoke smell. Once she is running, she starts slow then idles fine. after that no performance issues.
Why does my Ford Ranger have a hard time starting?
My 99, 4.0 ranger has a hard time starting when its cold out and it has sit over night. I usally have to crank it twice until it will start and when it dose start it hesitates a little and then idles fine. I have replaced the idle air control and the fuel filter. The engine runs good and strong.
What causes a loud grinding noise when making a turn?
Cause: Posi chatter due to improper lubrication; worn clutches or spider gears; improper assembly Noise:Banging, crunching, or popping while making a turn. Noise not affected by temperature Cause: Badly worn or broken spider gears Noise:Banging or heavy clicking every two to three feet during acceleration and deceleration
Why is my Ford Ranger making a clunking sound?
Meaning if you are having problems with bad bearings in your starter it wont show up there. I would pull the starter again, and hold the gear in the nose, and shake it. If you hear a clunking sound, its not a good sound. You need to replace that starter, the bearings have gone bad.