Is all 88 91 civic cluster the same?
The wiring and shape is the same for 88 and 89s and is the same between 90 and 91. So, if you have an 88 you can get a cluster from an 89 Si or an 88-89 CRX. Just don’t mix the years, the wiring and shape is much different.
Where is the speedometer located on a Honda Civic?
The vehicle speed sensor (VSS) gear is located on the transmission, and it sends an RPM signal to the engine control unit (ECU). The ECU then translates this signal into MPH, and relays that information to the speedometer in your car’s instrument panel.
How do you replace a speedometer on a Honda?
Unscrew the speedometer cable from the back of the meter assembly using pliers. Follow the cable down to the speed sensor located under the seat. Unscrew and remove the cable from the speed sensor. Run the replacement cable through the body of the bike down to the speed sensor. Attach the cable to the speed sensor.
Where is the cable for the speedometer located?
Slide underneath the dashboard on the driver’s side with the shop light. Look up under the dash, and locate the cable where it screws into the back of the speedometer cluster. Use a pair of pliers to unscrew the cap screw and pull it free. Use pliers to remove the horseshoe spring clip, if so equipped.
How do you jack up a Honda Civic?
Step 1 – Jack up the car. Park the car on a level surface. Place a pair of wheel chocks behind the rear wheels to prevent the car from rolling backwards. Look for the front jack point, and place your jack underneath it. While there are other suitable places you can use, this is by far the best and strongest jack point.
Where can I find the speedometer cable on my car?
Note: Some speedometer cables can be accessed by simply reaching underneath the dash while others may require the removal of either an access panel or the instrument cluster. If the speedometer cable cannot be reached, consult a repair manual. Step 5: Remove the firewall grommet.
Unscrew the speedometer cable from the back of the meter assembly using pliers. Follow the cable down to the speed sensor located under the seat. Unscrew and remove the cable from the speed sensor. Run the replacement cable through the body of the bike down to the speed sensor. Attach the cable to the speed sensor.
Where is the speed sensor on a Honda?
Follow the cable down to the speed sensor located under the seat. Unscrew and remove the cable from the speed sensor. Run the replacement cable through the body of the bike down to the speed sensor. Attach the cable to the speed sensor. Connect the other end of the cable to the meter assembly.
What causes a speedometer cable to break down?
The speedometer cable, although simple in design, breaks down like any other component. Speedometer cables fail from lack of lubrication, impact, wear and cable breakage. Connecting a speedometer cable requires a few simple steps and basic tools.