Is a Power Commander bike specific?
No. The connectors are different for each injection system on each bike. In theory you can snip the old connectors off and wire up new ones.
Is the power commander on my Roadking not working?
In December I purchased a Power Commander USB III for my 2008 Roadking. With the Power Commander installed on my bike it will not idle. After calling DynoJet and talking to the customer service rep. he told me to do several things.
Why do you need a power commander on a motorcycle?
This allows you to modify the stock settings and change the fuelling so that the air to fuel ratio can be set at an optimum level. For most riders, the appeal of a Power Commander is that it enables you to boost your bike’s horsepower and torque.
How can I tune my Power commander for my bike?
To get the best from a Power Commander you have to tune it to suit your motorcycle. This involves modifying the map or uploading a new map. You can plug it in and upload a pre-configured map for your bike, which will improve the throttle response as it can adjust the fuelling to suit.
What’s the fuel change range on a power Commander V?
Power Commander V takes the guesswork out of pairing efficiency with performance, keeping your focus where it belongs — on the journey ahead. Better than ever (and smaller than ever), Power Commander V now has a fuel change range of -100/+250%, automatically giving you the best mix of performance and fuel efficiency at all times.
This allows you to modify the stock settings and change the fuelling so that the air to fuel ratio can be set at an optimum level. For most riders, the appeal of a Power Commander is that it enables you to boost your bike’s horsepower and torque.
How do you adjust the power commander on a Harley Davidson?
Adjusting Your Power Commander Your Power Commander has been programmed with a base map for your application. You can adjust the base map or install an alternate map using your Computer. Please refer to the supplied CD-Rom for more information. You can also adjust your Power Commander using the face plate buttons as described below. 1.
Where is the power commander on a Harley Davidson Twin Cam 88?
1. Remove the seat. 2. Remove the left and right side covers. 3. From the left side of the bike route the Power Commander III cable over the frame rail and under the stock wiring harness in the area of the section of the seat. Make sure the seat does not put pressure on the Power Commander III cable. 4.
To get the best from a Power Commander you have to tune it to suit your motorcycle. This involves modifying the map or uploading a new map. You can plug it in and upload a pre-configured map for your bike, which will improve the throttle response as it can adjust the fuelling to suit.