Is a alternator hard to replace?
Replacing an alternator can cost you several hundred bucks at the local repair shop, but it’s one of the simplest repairs you can do at home. With a few tools and about an hour you can swap it out yourself — and keep your dough in your pocket where it belongs.
Is it easy to remove an alternator from an engine?
Since the typical alternator is bolted directly to the outside of the engine block, removing and replacing one is relatively simple in terms of labor. If your engine is equipped with a serpentine accessory belt, you’ll just need to release the pressure on the belt tensioner and then remove the belt.
Can a manual tensioner be used to replace an alternator?
The belt tensioner will only travel (swing) so far which can make installing the belt difficult. Never pry or force the belt onto the pulley. Vehicles with a manual tensioner or the belt tightens with the alternator, there should about ½ inch of deflection in the belt between the pulleys with the greatest distance between them. 7
How can you tell when it’s time to replace your alternator?
If it has specific voltage settings, you want it to be able to test up to at least 20 volts. Before you turn the car on at all, look for a large red wiring attached to a terminal on the back of the alternator. Touch the red positive lead from the multimeter to the bolt on that terminal.
Do you need to remove serpentine belt to change alternator?
As you loosen the bolts, the alternator will slide in the bracket under the tension of the belt. You may not need to remove the serpentine or accessory belt if it’s not damaged.
Since the typical alternator is bolted directly to the outside of the engine block, removing and replacing one is relatively simple in terms of labor. If your engine is equipped with a serpentine accessory belt, you’ll just need to release the pressure on the belt tensioner and then remove the belt.
The belt tensioner will only travel (swing) so far which can make installing the belt difficult. Never pry or force the belt onto the pulley. Vehicles with a manual tensioner or the belt tightens with the alternator, there should about ½ inch of deflection in the belt between the pulleys with the greatest distance between them. 7
As you loosen the bolts, the alternator will slide in the bracket under the tension of the belt. You may not need to remove the serpentine or accessory belt if it’s not damaged.
How to replace an alternator on a 1995 GMC?
Somewhere on your vehicle there is a tensioner pulley. You’ll need to move it enough to slip the belt off the pulley. Our ’95 GMC has a standard spring-loaded GM tensioner that required us to pull it back with a wrench.