How to turn off the Toyota RAV4 seat belt warning?
4) The dealer can go into your system through the OBD connector and turn off the buzzer using their Techstream scanner. If you want to do this yourself, you can purchase a Techstream scanner for about a grand and do it yourself.
What do the warning lights on a Toyota RAV4 mean?
Warning lights inform the driver of malfunctions in the indicated vehicle’s systems. *1: These lights turn on when the engine switch is turned to the “on” position (vehicles without a smart key system) or ignition on mode (vehicles with a smart key system), to indicate that a system check is being performed.
When does the warning light turn off on a Toyota?
If the front passenger’s seat is occupied, the front passenger’s seat belt also needs to be fastened to make the warning light (warning buzzer) turn off. The indicator light flashes after the ENGINE START STOP switch has been turned off to indicate that the system is operating.
Can a Toyota RAV4 airbag not go off?
Most current SRS systems detect whether there is a person in the passenger seat and if not, the airbag will not deploy. Can you imagine your liability if you loan or sell your car and the airbag did not go off during an accident and it is found that you modified the safety system?
How do you turn off the seatbelt alarm on a Toyota?
Turn the ignition back to the “On” position and hold the small knob for 10 to 15 seconds. After the time has passed, put on your seat belt (while holding the knob). Release the trip odometer knob to finish.
Can You disable the seat belt warning chime?
The seat belt warning chime can easily be disabled. Disabling the alarm is not illegal, in fact, the instructions can be found in your owner’s manual. Follow the procedure outlined to disable the seatbelt alarm in most 2004 and newer Toyota vehicles.
How to turn off the seat belt warning light?
3) Redneck disable – I’ve seen many people track down the offending buzzer buried deep into the dash and then clip the wire to it. As for the seat belt light, a piece of black electrical tape can easily cover that. 4) The dealer can go into your system through the OBD connector and turn off the buzzer using their Techstream scanner.