How to split the cases on a 2 stroke engine?
How to Split the Cases With or Without A Case Splitting Tool With the engine positioned on your engine building box, and with the puller attached to the engine case and leveled as discussed above, begin threading the puller’s push bolt in against the crankshaft while watching and listening for the cases to begin separating or binding.
How to replace crank seals on Yamaha ct1-175?
Replace Yamaha 2 stroke crank seals – Chin on the Tank – Motorcycle stuff in Philadelphia. Since a lot of friends have been getting 70’s and 80’s Yamaha 2 stroke dirt bikes, and I’ve done this a couple times now on my CT1-175 due to the motor blowing up, I figured I’d do a basic write up on how to change the crank seals.
How to identify a Yamaha from its engine numbers?
Yamaha models can be identified by locating and decoding the crankcase engine number. Yamaha uses a standardized numbering system, which is broken into four sections: model code, basic part number, design code and the finish code. Because the crankcase engine number is actually the part number,…
What kind of parts are in a Yamaha motorcycle?
HONDAOff Road Parts HONDAATV/QUAD Parts HONDAScooter Parts Husaberg HUSABERGPARTS HUSABERGMotorcycle Parts HUSABERGOff Road Parts Husqvarna HUSQVARNAPARTS HUSQVARNAMotorcycle Parts HUSQVARNAOff Road Parts Kawasaki
How do you repair a split crankcase engine?
In all cases you will need to pull the engine from the frame and remove the clutch, internal shifter linkage, crankcase bolts or screws and maybe the flywheel and electrical coils, depending on what repair has to be done. If the crankcase is split vertically (Up and down) You will have to remove the cylinder and cylinder head.
How do you split a multi cylinder engine?
Most multi cylinder engine crankcases are split horizontally. Remove the bolts and nuts on both the top and bottom of the engine, clutch, shift linkage, ETC. Now look at the engine where the cases join together. There usually is a thicker area of the crankcase where you can tap with a dead blow hammer.
Where can I buy a 1980 Yamaha IT175?
You can find this restored 1980 Yamaha IT175 for sale here on Craigslist in Walla Walla, Washington with a price of $3,699. Or you can also find it here on the Restoration X Cycle Facebook page — where there are additional photos of the bike — for a slightly cheaper price: $3,500.
What happens if you split the crankcase on a motorcycle?
Because the edge is sharp and flat on one side, angled on the other and quite wide, very little or no damage is done to the crankcase. It is important NOT to damage the edge of the crankcase. If you do damage it, it will not seal right and you will have an oil leak. The crankcase is made of aluminum and it can be damaged very easily.