How to resolve no power, no post?
Press and hold the M key and the Power button down simultaneously: If an error is detected the Battery status LED lights up Amber and you need to contact us If the Battery status LED does not light up, then no fault is detected with the motherboard
What to do if there is no check engine light?
NO Check Engine Light! – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred. Please try again later.
Why does my smallblock Chevy have no power?
If it doesn’t, and you find no other issues such as fuel starvation or exhaust restrictions, your camshaft could be excessively worn. Many older, higher mileage smallblock Chevys develop flattened cam lobes over time, resulting in lack of power and, sometimes, backfiring and the like. Lack of power is the most common symptom of flattened cam lobes.
When to interrupt power to a pumptec motor?
Pumptec interrupts power to the motor whenever the motor load drops below a preset level or the load drops quickly. Pumptec is optimized to work with Franklin 2- and 3-wire single-phase motors from 1/3 to 1.5 hp. An underload (dry well) adjustment is provided to address unusual situations. Protection Features
How to reset PCM and check engine light?
First, park your truck and turn it off. Pull the hood lever under the driver’s side dash, and then pull the safety catch on the front of the hood to open it. Find the power distribution center (PDC); it will be a black box near the battery. Unlatch and open the cover of the PDC.
Press and hold the M key and the Power button down simultaneously: If an error is detected the Battery status LED lights up Amber and you need to contact us If the Battery status LED does not light up, then no fault is detected with the motherboard
Why do I need to Reset my Check Engine light?
To make it go away, you have to reset the powertrain control module (PCM), which among its many jobs is also in charge of the check engine light. There are other reasons why you would need to reset the PCM, such as after the installation of aftermarket components that require a PCM reset so the truck can fully adjust to new components.
Pumptec interrupts power to the motor whenever the motor load drops below a preset level or the load drops quickly. Pumptec is optimized to work with Franklin 2- and 3-wire single-phase motors from 1/3 to 1.5 hp. An underload (dry well) adjustment is provided to address unusual situations. Protection Features