How to reset the steering sensor after replacing a battery?
After replacing the battery, he put the key in the ingnition and turned the stearing wheel all the way to the left and then all the way to the right, did this three times. That did the steering sensor reset, then he rolled all four windows down and held the switch in down position for few seconds and did the same thing with windows rolled up.
How do you change battery on Mercedes E55?
I had exactly the same thing happen when the tech replaced the battery on my E55. After replacing the battery, he put the key in the ingnition and turned the stearing wheel all the way to the left and then all the way to the right, did this three times.
What should I do if my battery goes out on my 1999 SL500?
I have a 1999 Sl500. I just replaced the battery today. Upon replacing, the dash warning lights for “BAS ESP and ABS” are still lit and will not go out. Is there something that I can do to reset, or do I have to take to dealer.
What to do when your Mercedes battery goes out?
To do so, turn electronic key in steering lock to position 2, move and hold switch in direction (3), until the sliding/pop-up roof is completely raised at rear, and hold for additional 1 second. running. Turn steering wheel completely to the left and then to the right. The BAS/ESP malfunction indicator lamp should go out.
Is the analog clock on my 2007 S550 correct?
Hi, I have a 2007 S550 with the same issue, command clock is correct but analog clock is 1 1/2 hours behind, date is reading June 28, 2013. When I try to adjust the time the minutes on the command system jump in 30 minute increments and the clock does not move. The date will adjust but goes back to 2013 upon exit.
Why is the clock on my Mercedes Benz not working?
The IWC clock in this W221.177 was also not adjusting the time as expected with the clock – expected meaning adjust the time on the COMAND as soon as the Time menu is exited after setting Time Zone, the analog clock begins moving to the set time on the COMMAND. This one did not do that, and was generally within 60 minutes off.
How do you set the analog clock on a Mercedes Benz?
Setting the time (and the date) are done via the COMAND system Vehicle>System Settings>Time menu, and the instructions begin on page 213 of the 2007 Owner’s Manual (YouTube should not have been necessary). clb0099’s problem seems to be that his analog clock is not accepting the settings made in COMAND.
How can I change the time on my car clock?
My solution was to make sure that the real 12 midnight had past (not the clock) and on the following morning, start the car, and reset the clock in COMAND. Just before you reset, it will show 12:00, so when you see that, you now have the ability to change the time.