How to reset the change engine oil light?
Press and hold the check button on your steering wheel for several seconds. It should give you a confirmation that the check engine oil display has been reset. Turn off the ignition then start the truck. If it worked, then the light should come on for a second to do a check then shut off. Figure 1. “Change Engine Oil” light.
What kind of oil do I need for a 4.8L V8?
(Note – The 4.8L, 5.3L, 6.0L and 6.2L V8 engines all require 6 quarts (5.7L) of new SAE 5W-30 oil for an oil change with filter replacement. The 4.3 V6 engine requires 4.5 quarts (4.3L) of oil.) Be sure to record the oil change in your truck’s service records.
How to do an oil change on a Vortec 4800?
Pour in about 5 quarts of the Vortec 4800 engine’s 6 quart total capacity for an oil change with oil filter replacement. It is far better to have a little less than enough oil in the engine than too much oil. Temporarily replace the oil filler cap and push down the oil level dipstick.
How to reset the change oil message on a Chevrolet?
Press and hold the “Reset” button on your information center (check mark symbol) until the “Oil Life” display changes to 100 percent. Turn your ignition to position “A” (Lock/Off). 2002 to 2006 Chevrolet Silverado. Insert your key into the ignition, and turn it to position “A” (Run/On) without cranking the engine.
How to turn off the change oil light in a Ram 1500?
Insert the key into the ignition. Turn it to “On” but do not start the truck. Press the gas pedal to the floor and release it three times within a 10-second period. Turn the ignition key to the “Off” position. Start the truck to confirm that the “Change Oil” message has cleared. Repeat the process if the message still appears.
Press and hold the check button on your steering wheel for several seconds. It should give you a confirmation that the check engine oil display has been reset. Turn off the ignition then start the truck. If it worked, then the light should come on for a second to do a check then shut off. Figure 1. “Change Engine Oil” light.
(Note – The 4.8L, 5.3L, 6.0L and 6.2L V8 engines all require 6 quarts (5.7L) of new SAE 5W-30 oil for an oil change with filter replacement. The 4.3 V6 engine requires 4.5 quarts (4.3L) of oil.) Be sure to record the oil change in your truck’s service records.
Press and hold the “Reset” button on your information center (check mark symbol) until the “Oil Life” display changes to 100 percent. Turn your ignition to position “A” (Lock/Off). 2002 to 2006 Chevrolet Silverado. Insert your key into the ignition, and turn it to position “A” (Run/On) without cranking the engine.