How to reset PassLock on GMc?
How to Reset the Passlock System on GM Cars
- Insert your key in the starter, start you car as you usually would and let it stall. Keep the key in the “On” position.
- Wait until the “Theft Sys” light on your dashboard stays on without blinking. This will take approximately 10 to 15 minutes.
How to reset a PassLock?
Thankfully this is an easy fix.
- Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.
- Look at the dashboard and locate the theft system light.
- Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.
How to reset PassLock 3 security system on Chevy?
But here are some more articles to help Passlock III reset procedure, reset security system on chevy, buick, oldsmobile, cadillac, pontiac, saturn, hummer. Passkey III Reset procedure. Make sure the battery if fully charged because this procedure may take up to 30 minutes and you cannot start the vehicle during this time.
Can You disable the PassLock on a GM car?
The following instructions will allow you to disable the PassLock security in quite a few GM Vehicles. •This will allow you to install a remote starter and not have to purchase a bypass. •Avoid Costly repairs for an already broken PassLock System.
Is there a way to reset the PassLock system?
To cope with this pesky glitch you can reset the passlock system when starting your car. Insert your key in the starter, start you car as you usually would and let it stall.
How do I Turn Off the PassLock sensor?
•The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK. The vehicle learns the Passlock Sensor Data Code and/or resistance on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.