How to reset a Saab 9-3 engine management light?
Only problem is the EML has come on (it wasn’t on before I cleaned it). I tried disconnecting the negative battery cable for an hour but this hasn’t worked. Does anyone know which fuse to pull out that might reset it.
Why is my Saab check engine light on?
This is not a normal “wear and tear” issue, but an issue dealing with parts that were doomed from the beginning. The contact owns a 2007 SAAB 9-3. The vehicle stated that while driving approximately 55 mph, the check engine warning light illuminated. The failure occurred on several occasions.
Are there any problems with the Saab 9-3?
SAAB 9-3 owners have reported 26 problems related to check engine light on (under the engine and engine cooling category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of SAAB 9-3 based on all problems reported for the 9-3.
Why is the EML light off on my Saab 9-3?
Code reader arrived today. Plugged in it and got code P0400. Looked it up in the book provided, and got “EGR Flow Malfuntion” (surprise, surprise!). So just cleared the code and the EML light off, and went I for a spin. Thought it just needed to be cleared, great. Started the car again and EML back on.
How did I Fix my Saab check engine light problem?
The repair consisted of removing and replacing all 8 intake valves, hand lapping them, removing and replacing all valve seals, and refinishing the head mating surface. The repair was very expensive, several thousand dollars. I’ve had the car back for a couple of weeks and the problem is gone.
SAAB 9-3 owners have reported 26 problems related to check engine light on (under the engine and engine cooling category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of SAAB 9-3 based on all problems reported for the 9-3.
Where is the fault code stored on a Saab?
Since a fault code will be stored in your Saab’s OBD computer, you can use an OBD-II scanner to read those codes. When your Saab check engine light comes on, you may notice:
What causes MAF sensor to go bad in Saab?
MAF sensor may function fine when the engine is cold then start to malfunction once the engine warms up. A coolant temperature sensor can go bad with time, causing the engine to run rich and preventing it from going into the ‘closed-loop’ mode.
What does the Check Engine light mean on a Saab?
When your Saab check engine light comes on, you may notice: Engine shaking or juddering. Check engine light flashing. In some cases, you may not notice any performance issues at all, as would be the case if you forget to tighten the gas cap. With a ‘check engine’ light on, the first thing you need to find out is what caused it.
How much does it cost to rebuild a Saab 9 3?
Had a compression test following several check engine lights and multiple readings diagnose a p0300 engine code . Cold and warm compression test showed cylinder 2 compression well out of specification. Documents available upon request. Quoted $4000 for engine rebuild. See all problems of the 2008 SAAB 9-3 .
Only problem is the EML has come on (it wasn’t on before I cleaned it). I tried disconnecting the negative battery cable for an hour but this hasn’t worked. Does anyone know which fuse to pull out that might reset it.
This is not a normal “wear and tear” issue, but an issue dealing with parts that were doomed from the beginning. The contact owns a 2007 SAAB 9-3. The vehicle stated that while driving approximately 55 mph, the check engine warning light illuminated. The failure occurred on several occasions.
Had a compression test following several check engine lights and multiple readings diagnose a p0300 engine code . Cold and warm compression test showed cylinder 2 compression well out of specification. Documents available upon request. Quoted $4000 for engine rebuild. See all problems of the 2008 SAAB 9-3 .
Why is the EGR light on on my Saab?
It’s mad alright. This happens to nearly everyone who routinely cleans the EGR valve. No EML on before the clean, then once you put it back together the light comes on. Mine is on for over a week now.
What to do if your engine management light is amber?
In the majority of cases, the car will need to be connected to diagnostic equipment to determine exactly where the fault lies. In many cases, the light operates on a colour-coded basis. An amber EML doesn’t necessarily point to an unfolding emergency – you should be able to continue on your way and seek advice on reaching your destination.
Code reader arrived today. Plugged in it and got code P0400. Looked it up in the book provided, and got “EGR Flow Malfuntion” (surprise, surprise!). So just cleared the code and the EML light off, and went I for a spin. Thought it just needed to be cleared, great. Started the car again and EML back on.
It’s mad alright. This happens to nearly everyone who routinely cleans the EGR valve. No EML on before the clean, then once you put it back together the light comes on. Mine is on for over a week now.
Where is the right tire pressure on a Saab 9-3?
The right tire pressure is NOT on the side of your tire btw 2008 Saab 9-3 2.0T 2.0L 4 Cyl. Turbo Wagon (4 Door) Quick fix for minor power steering fluid leaks