How to replace the spark plug on a Porsche Carrera?
Replace it with a new one (see Figure 3 and also Figure 6 of Pelican Technical Article: Porsche 911 Carrera Camshaft Swap and Valve Train Repair ). Spark plug removal is easy. You just need the right spark plug wrench.
How to repair a Porsche Carrera sunroof transmission?
If you have determined that the motor needs to be replaced, remove the two Torx bolts that hold it up in place on the roof and then carefully maneuver the motor out of the sunroof transmission. Also remove the electrical connection going to the motor.
How to drop a Porsche 911 Carrera engine?
Finally, unbolt the 13mm (996 only) bolt holding the airbox inside the engine compartment (red arrow) and carefully lift the airbox out of the car. Disconnect either the throttle cable (on early cars) or the electrical connector for the throttle (on later cars).
How to replace the air filter on a Porsche Carrera?
( Pelican Technical Article: Replacing Your Porsche Carrera Air Filter (996/997)) Remove accelerator cable from throttle body or disconnect electronic throttle body. (Picture 2) Disconnect fuel tank vapor hose. (Picture 3) Disconnect brake booster fitting to intake manifold. (Picture 4) Remove serpentine belt.
How to remove the engine from a Porsche 911 Carrera?
(Pictures 38 and 39) Open the engine decklid and remove the airbox. Begin by loosening the hose clamp holding the boot to the throttle body (green arrow), then squeeze the tabs on the MAF connector to release it (yellow arrow). Now open the two harness holder clips (purple arrows). Remove the oil filler tube from its clip (blue arrow).
( Pelican Technical Article: Replacing Your Porsche Carrera Air Filter (996/997)) Remove accelerator cable from throttle body or disconnect electronic throttle body. (Picture 2) Disconnect fuel tank vapor hose. (Picture 3) Disconnect brake booster fitting to intake manifold. (Picture 4) Remove serpentine belt.
If you have determined that the motor needs to be replaced, remove the two Torx bolts that hold it up in place on the roof and then carefully maneuver the motor out of the sunroof transmission. Also remove the electrical connection going to the motor.
How do you replace sensor on Porsche 911?
Remove bracket with both sensors to work bench and replace sensor (s) as needed. ♦ Once bracket has been removed, sensor clearance gap must be reset as described below. When installing sensor mounting bracket, position sensor tip correct distance (A) from toothed wheel using slotted bracket mounting bolt hole (arrow).