How to replace the radiator on a Jeep Liberty?
Replace Liberty Radiator – Part 1 of a 2-part series showing how to remove and replace the radiator in a 2002 – 2007 Jeep Liberty. This particular model has a 3.7L V6 and is 4WD, but the same basic method applies to all models in this year-range. Part 1 covers removal, part 2 covers installation.
Why is my radiator leaking in my Jeep?
Just had a better look at the radiator, and there is a very small vertical crack along the seam in the plastic end cap of the radiator. Can imagine that this very small leak could easily end up in a complete separation of the cap when the system is pressurized. 1.5 year ago, when i changed my waterpump, i also changed the thermostat.
Is it possible to stop a radiator leak?
No cracks visible, so do you guys or girls have good experience with radiator leak stop, or is that a complete no-go. Either way, it will probably mean a new radiator in the (near) future, so which is the best place to buy a good quality radiator?
What is the diagnostic code for a jeep check engine light?
Refer to our Generic OBD II code list for definitions on all other Jeep diagnostic trouble codes. Manufacturer Specific Codes P1105Open Or Shorted Condition Detected In The Baro Read Solenoid Control Circuit – Read Our Article on Automotive Circuit TestingFor Help With This Jeep Check Engine Light Code P1192Inlet Air Temp. Circuit Low
When was the last year a Jeep Liberty last?
The first generation 2002-2008 had the most problems, with 2006 being the worst. 2009-2012 Liberty’s fared better. If you would like to know which Liberty models fared best, we have broken down the years and models for you to ensure that your Liberty will have a better chance of being one that lasts.
How do you remove the grille on a Jeep Liberty?
Step 1. Open the hood of your Liberty, and locate the six clips along the top edge of the grille. Release all six of them, and roll the top of the grille forward. Locate and release the two retaining hooks below the headlights to remove the grille from the Jeep.
Are there any problems with the Jeep Liberty?
Transmission issues, failing window controls, and airbag failures were rife and the ride uncomfortable. Despite the window, sunroof, and corrosion failures, the Liberty still manages to hold its reputation for durability and reliability.
Replace Liberty Radiator – Part 1 of a 2-part series showing how to remove and replace the radiator in a 2002 – 2007 Jeep Liberty. This particular model has a 3.7L V6 and is 4WD, but the same basic method applies to all models in this year-range. Part 1 covers removal, part 2 covers installation.
How to reset an airbag light you it still runs?
Start the engine. The SRS light should come on for seven seconds, and then shut off and stay off. The airbag light has been reset. If you continue to drive your vehicle with the SRS light illuminated, you may risk an accidental deployment of the airbag. “How To Use Automotive Diagnostic Scanners (Motorbooks Workshop)”; Martin; 2008
Why does my Jeep kJ not have coolant?
Click to expand… Just tells you that you do not have a air pocket trapped in the heater core in a KJ,most common place for it to get trapped. It’s opening the rad cap that lets the air out of the system. Otherwise the system stays pressurized and the coolant level will never drop to replace the air in the system with coolant.
How to add coolant to a 2002 Jeep Liberty?
2002 Jeep Liberty Limited 3.7L V6 Change a rear blinker Don’t send mixed signals – if your turn signal doesn’t blink, or blinks rapidly, you likely have a burnt out bulb 2002 Jeep Liberty Limited 3.7L V6 Change an engine fuse If you have an electrical component that doesn’t work, try replacing the fuse first 2002 Jeep Liberty Limited 3.7L V6
What happens when you remove the coolant cap on a Liberty?
These coolants will typically say 50/50 or pre-mixed on the front of the coolant bottle. Removing the coolant reservoir cap on a warm engine could cause the cap to fly off at a high rate of speed and fluid to spray out of the reservoir. Always wear safety goggles when working on your Liberty.
Where is the draincock on a Jeep Liberty?
SERIOUS BURNS FROM COOLANT CAN OCCUR. (1) DO NOT remove radiator cap first. With engine cold, raise vehicle on a hoist and locate radiator draincock. NOTE: Radiator draincock is located on the left/lower side of radiator facing to rear of vehicle. (2) Attach one end of a hose to the draincock.
What kind of coolant do you use on a Jeep Liberty?
CAUTION: Failure to purge air from the cooling system can result in an overheating condition and severe engine damage. (2) .Fill system using a 50/50 mixture of Mopar Hoat or Zerex G05 coolant and low mineral content water. Fill pressure bottle to service line.and install cap.
SERIOUS BURNS FROM COOLANT CAN OCCUR. (1) DO NOT remove radiator cap first. With engine cold, raise vehicle on a hoist and locate radiator draincock. NOTE: Radiator draincock is located on the left/lower side of radiator facing to rear of vehicle. (2) Attach one end of a hose to the draincock.
How do you replace the radiator hose on a Jeep Cherokee?
Attach the upper and lower radiator hoses to the radiator and reinstall the original hose clamps if they are in good condition. If the original clamps were damaged when you removed them, then replace them with new ones. Replacement clamps can be purchased from any Jeep parts department.