How to replace clutch side grip on Harley?
Clutch Side. 1 Slide clutch side grip into place. 2 Mark location for drilling divots. 3 Remove grip, drill divots. 4 If desired, apply grip adhesive to bar. 5 Slide grip into position, tighten placement screws. 6 Allow glue to dry according to directions.
How to change throttle grip on Harley Davidson?
Throttle Side 1 Slide throttle grip or throttle tube into place 2 If using a throttle tube, slide grip over tube 3 Tighten housing 4 Check to see that grip returns to neutral position 5 If grip sticks, adjust housing tightness or slide grip out slightly
Why are the grips on my Harley Davidson so bad?
Either your existing grips are causing you hand problems or you just don’t like the look of what’s currently on your bike. For me the story was a combination of both. The stock Harley-Davidson grips are terrible in both look and function, so I wanted an upgrade.
How do you close the modal on a Harley Davidson?
This is a modal window. This modal can be closed by pressing the Escape key or activating the close button. This is a modal window. Sign up for premium membership and get access to our best Harley repair videos and step-by-step instructional projects.
How do you replace handlebar grips on a Harley Davidson?
Use your hacksaw to cut off the very end of grip with cap. If you nick the any blemish. Spray carburetor cleaner between the grip and the handlebar to make it easier to remove; twist off grip. the screws from the left-hand controls. This will enable you to separate the two halves of the switch “pod” on each control cover. To halves.
How to replace the clutch on a Harley Davidson?
Clutch Side 1 Slide clutch side grip into place 2 Mark location for drilling divots 3 Remove grip, drill divots 4 If desired, apply grip adhesive to bar 5 Slide grip into position, tighten placement screws 6 Allow glue to dry according to directions
How tall can handlebars be on a Harley Davidson?
Most the time you can go as tall as 12″ aftermarket handlebars without having to replace wires, cables, and lines. I said, “most the time”, so you need to do your own research for your particular year and model before you begin your project. Get the tutorial video now and get started!
Either your existing grips are causing you hand problems or you just don’t like the look of what’s currently on your bike. For me the story was a combination of both. The stock Harley-Davidson grips are terrible in both look and function, so I wanted an upgrade.