How to replace a bad brake light on a Hyundai Veracruz?
Sourcing a switch online at http://www.rockauto.com/ is the best way to go. How to remove the tail light bezel on a Hyundai Veracruz to replace a bad brake light? Undo the two bolts on the side of the lamp under the gate and remove them.
How do you remove a tail light from a Hyundai?
Undo the two bolts on the side of the lamp under the gate and remove them. The lamp can be pulled straight back to release the outboard side locating pin, but this may need considerable effort. It might be easier to use a small screwdriver tip to lever it out.
When do I need to replace my tail light?
It might be easier to use a small screwdriver tip to lever it out. If there’s water inside the lamp it’s probably cracked and will be replaced under a recall campaign which applied to vehicles between 5-19-07 and 7-31-07. If the bulb has blown it is covered for free replacement under a 5-year/60,000 mile warranty.
Where is the tail lamp relay on a Hyundai?
The tail lamp relay can be found in the instrument panel fuse box, on the left of the dash, as shown below: Also illustrated in the above image is the tail lamp relay built into the junction block. To fix the problem the fuse box needs to be replaced.
How to remove and replace side rear view mirror Hyundai?
How to Remove and Replace Side Rear View Mirror Hyundai Santa Fe IN 1 MINUTE!!! – YouTube How to Remove and Replace Side Rear View Mirror Hyundai Santa Fe IN 1 MINUTE!!! If playback doesn’t begin shortly, try restarting your device. BOUGHT MERCEDES FROM COPART CAR AUCTION. GREAT FIND
Sourcing a switch online at http://www.rockauto.com/ is the best way to go. How to remove the tail light bezel on a Hyundai Veracruz to replace a bad brake light? Undo the two bolts on the side of the lamp under the gate and remove them.
Undo the two bolts on the side of the lamp under the gate and remove them. The lamp can be pulled straight back to release the outboard side locating pin, but this may need considerable effort. It might be easier to use a small screwdriver tip to lever it out.
The tail lamp relay can be found in the instrument panel fuse box, on the left of the dash, as shown below: Also illustrated in the above image is the tail lamp relay built into the junction block. To fix the problem the fuse box needs to be replaced.
It might be easier to use a small screwdriver tip to lever it out. If there’s water inside the lamp it’s probably cracked and will be replaced under a recall campaign which applied to vehicles between 5-19-07 and 7-31-07. If the bulb has blown it is covered for free replacement under a 5-year/60,000 mile warranty.
How do you turn off the tail light on a Hyundai Tucson?
Once this is done pull the lamp straight back which will release it from the pin connection on the other side. Pry the lamp away gently from the body beginning at the front end of the lamp housing. Why do the parking and tail lights on a Hyundai Tucson stay on and drain the battery even after the ignition is turned off?
Why are the tail lights stuck on my Hyundai?
This is the outcome of a problem with the tail lamp relay which is not unusual for this vehicle. The relay gets stuck, even though the key is out, and allows the battery to power the tail lights and parking lights till eventually the battery discharges completely.