How to remove porsche 911 door panel?
To remove the door panel you begin by prying out the mirror triangle piece (pull out from the bottom then lift straight up), unplugging the harness, and removing the door panel T30 screw behind it. Then remove the T20 screw inside the door handle pull and remove the handle piece.
What do you need to remove a car door panel?
This padded cardboard item is held on by a series of screws and plastic clips that must be removed to service such items as a window switch , door lock and window motor and regulator. All door panels basically perform the same task though the process a door panel removal will vary slightly for each vehicle.
How do you remove the door panel on a Porsche Boxster?
With the door panel loose, pull it out from the bottom, and release the door lamp bulb from its holder (red arrow). Pull the panel off of the door and then reach around the rear to disconnect the door handle cable (purple arrow). You may have to clip a zip tie in order to disconnect the cable.
Where are the trim pieces on a door panel?
Most door panels will have small trim pieces located at the top of the panel at either the right or left side. Use a small screw driver or trim removal tool and detach (pop off) any trim pieces above the door panel.
How do you remove fascia from a door?
Use a small screw driver or trim removal tool and detach (pop off) any trim pieces above the door panel. Here is an upper trim piece to the left of the panel. These pieces must be removed before removing the panel. 2. Remove Plastic Fascia Pieces
How do you remove a Porsche Carrera door panel?
To remove or replace the window switches you will need to remove the door panel. (see Pelican Technical Article: Porsche 911 Carrera Door Panel Removal). Once the panel is off, you can remove the window switch by first disconnecting the wiring. Squeeze the tap (red arrow) and pull straight back.
How to replace the regulator on a Porsche Carrera?
The first step in replacing either the regulator or the power window motor is to remove the door panel (see Pelican Technical Article: Porsche 911 Carrera Door Panel Removal ). Make sure that you eliminate the power window switch as a potential problem before you start tearing into your door.
Can a broken window regulator be replaced in a Carrera?
Having a broken window regulator can surely put a damper on that. The first step in replacing either the regulator or the power window motor is to remove the door panel (see Pelican Technical Article: Porsche 911 Carrera Door Panel Removal ).
How to adjust window height in Porsche Carrera?
E: Adjust the window height by removing the outer plugs in the bottom of the door and using an E6 Torx socket to turn the stopper (counterclockwise = higher window). F: Check the window rake angle by placing a sheet of paper in the window and rolling it up.