How to remove cylinder heads on the MBE 4000?
The MBE 4000 engine has individual heads for each cylinder. To remove one head, follow these instructions, step by step. To remove all the heads, repeat each step in these instructions, as applicable, for all six cylinders.
How to remove fuel line from MBE 4000?
Place the other wrench on the high-pressure line fitting. Turn the wrench on the high-pressure line fitting while holding the other wrench on the thrust bolt. Remove the high-pressure fuel line from the transfer-tube and unit pump. To prevent any dirt from entering, cover the openings in the unit pump and the transfer-tube.
Where is the thrust bolt on a MBE?
Using a paint pen, mark the location of the thrust bolt. Place one wrench on the thrust bolt to secure the transfer-tube. Place the other wrench on the high-pressure line fitting. Turn the wrench on the high-pressure line fitting while holding the other wrench on the thrust bolt.
When do I need to service my MBE 4000?
When dealer service is necessary, this is mentioned in the table. The batteries are damaged or weak. Test the batteries. Replace them, if needed. The ignition switch is damaged. Replace the ignition switch. The battery cables are damaged and/or corroded. Clean or replace the battery cables. The starter is damaged and/or worn.
Is the intake air preheater installed on the MBE 4000?
No intake air preheater is installed, and it is too cold to start without one. Install an intake air preheater. The intake air preheater is malfunctioning. Check the intake air preheater, and replace it, if necessary. The camshaft TDC sensor and/or the crank angle position sensor are out of adjustment.
How to repair MBE 4000 block to block joint?
The attached service information has been developed and released to provide the appropriate information for diagnosing and repairing MBE 4000 cylinder blocks at the cylinder head to block joint.
When do I need to troubleshoot my MBE 4000?
The tables that follow are designed to identify the causes of common problems, suggest further checks and appropriate remedies. When dealer service is necessary, this is mentioned in the table. The batteries are damaged or weak.